Search results

It's just a hall effect sensor? I'm surprised they fail. I just checked and the other car has the same sensor, swapping them now and see how it goes.

I just checked the 'space wagon' service manual, and it says: Code No.23 Camshaft position sensor system So it looks like you might be right blackvr. They are $125 on ebay...

So the Crank Angle Sensor, not the Cam Angle sensor. i.e. This one...

Okay, it worked, I got two long flashes followed by 3 short ones, so a Code 23?

The ignitor? Not 100% what you mean there. Sometimes first thing in the morning it does the start, run for 5 seconds then kick off again, but much less so now with a fully charged battery, (but could be coincidence). I'll have to try the code readout next time it throws an engine check light...

Spoke too soon, stopped going around a corner yesterday arvo when picking up the kids. It did about five minutes of start then stall before running again and getting us home. I'll try and check the codes tonight and see what it says, the engine light did come on.

Thanks so much. Checked the crank angle sensor with the cro and it is okay. Great to know I can check the codes. Now it's confession time, I had previously put a new battery in and had the same problem as before. I noticed this morning that the alternator belt was a bit loose. Tightened it up...

It has what looks like the connector in this thread: http://www.justanswer.com/mitsubishi/61eae-1998-mitsubishi-diagnose-the-check-engine-light-flash-codes.html as well as another connector that only has a few pins present. I'll grab a photo. I don't have an immobiliser unless there is a...

My UG Nimbus randomly has the engine cut out while driving. There isn't any warning that it is about to happen, the engine just cuts out. Trying to start the car results in it starting, running for a second or two and then stopping again. This can happen for 20 starts in a row, or sometimes...

It turns out that inside that pump/gauge assembly there is another part to it next to where the fuel pump connects that has a rubber o-ring to seal the end of the tube. That o-ring had collapsed and was blocking part of the outlet port. I replaced the o-ring and the car now starts, runs for...

I'll check the voltage and do a bucket test today, I'll check the pickup line as well, it picks up from both sides of the tank from memory.

I get voltage at the pump connector, can't find an under bonnet filter. If I disconnect the hose at the pump end, the pressure is about the same as at the injector rail, ie the fuel spurts out about a foot or so. So it doesn't appear to be the lines/rail etc as the problem is the same at the...

I put in a new pump and filter and am still only getting the same pressure as before. Now I'm stumped.

Did you have any luck?

Mitsubishi wants $700 for the pump. I can get a denso one online for $95...

Thanks, that is exactly what I needed to know. I stuck an oscilloscope on the injectors, and I'm getting what looks like a sensible pulse. Disconnecting the fuel line at the rail, fuel comes out but would go maybe 10cm past the end of the hose when I jumper the relay. About the smae if I...

I have a 1999 stock UG nimbus that is refusing to start, If I spray aerostart into the air intake, it will start and run for a few seconds and then stop. I can hear the fuel pump kick in, but how much fuel pressure should these things have? I disconnected the fuel at the injection rail, and fuel...

They have ODB1 cables on their site: http://evoscan.com/m...obd2-can-cables and this lists evo I, II & 3 as supported. http://www.evoscan.com/evoscan-gps-obdii-cables/details/7/1/performance-vehicle-pc-diagnostic-interfaces/evoscan-obdi-/-aldl-12pin but not sure if they will work with the guage...

Well, in case anyone was wondering, the SSG loom seemed to work. Found some useful manuals here: You will need to copy and paste it into the browser, as it doesn't work if you click through from another site. http://tech.mirage-p...ce.com/Manuals/ The folder Indy.pp.ru Manuals/ has RVR/Nimbus...

If I can find a workshop manual for the HSG, I will definitely buy one. Cheers -Pete