Search results

I have one from a VR4, but the plug is different its square and on my loom is a flat Is 509 the last digits of the part number? or what does it stands for

tried it, still the same. I am running the GSR air flow meter, is the evo different?

the iridium I've fitted had .8 gap adjust gap of the Bosch , fitted, still the same. I tried other set of coils too. fuel pressure 3,5 bar idle rises to 4 bar at about 3000+

Had a set of iridium plugs, fitted but same thing. I'll check the fuel pressure now

Bosch super plus measured gap 1mm

Problem number one is fixed. I got a near new alternator, problem still present. Run a new (thicker) wire from the alternator to the fusible link. Tested great with 14.4 volt. Problem number two is still present. does not rev above 4000 rpm.

As it says in the post. At the Fusible link arrive only 11.9 volt. The Voltage drop in the wire saved my fuse and electronic. I'll pick up another alternator tomorrow and test again.

Hi guys, I have currently two problems with my 1994 GSR with 4G63 (EVO3 injectors and ECU) conversion. problem one. Alternator output only 11 volts, so I grabbed one from the local wrecker. This one has 31 volt output??? So I went back and got another one fitted it and the same result. Measures...

got one. newish I think its a 1.0bar Actuator $65 shipped

I got a grill, silver $30

I got a clutch plate for it, new never fitted. I think its 8 puck. I'll look tomorrow and send you a pic if interested. $70

ok, damn. I'm short at the moment, need to pay some other bills first.

where in Mel are you? injectors are still there?

I got a good stock ECU from a 1991 VR4 if you need one

I ordered one. thanks

sorry to much for me.

found the pinouts, give it a go. how much for the ECU? I just got stock setup.

I was going to change the connectors, but the amount of pins are different too. With that I'll need the pin assignment of both ECU/cars

Hi guys, I have trouble with my 4G63T conversion. Engine and ECU is out of a 1991 VR4 AUS spec in my 1994 GSR JAP spec. The ECU does not fit on the GSR loom, the plugs are different. I do have the VR4 loom, but first of all its cut in 2 pieces and second it does not plug in to the loom of the...