4g93t

4GTuner

Help Support 4GTuner:

  1. F

    Jumbuck 4g93t swap HELP!

    Hey all. So I'm in the middle of converting my Proton Jumbuck to a 4g93t. I have pulled the 4g15p, swapped the box over to the new block and dropped her into the buck. Wiring loom is in and I'm hitting a few bumps along the way that I'm hoping someone can help me with. There will be a few...
  2. cubic

    Mitsubishi 4G93T 4G93 Turbo ECU CC GSR JAP SPEC MD307377 EPROM

    Mitsubishi 4G93T 4G93 Turbo ECU CC GSR JAP SPEC MD307377 - $150 shipped Australia Wide Part Numbers : MD307377 E2T38386 4607 M MD307377 – 1994 JDM GSR/LIBERO GT - EPROM Suitable for 1.8L 4G93 Twin Cam Turbo, suitable for turbo conversion on Proton Satria GTI 4G93P Mitsubishi 4G93, 4G93T...
  3. svanh1993

    satria gti forge build and front end swap

    hey guys thought I'd put up a few picks of my updated build as the last high compression turbo build finally let go on the old setup I made (can see the old build on my page ) I did everything from scratch by my self now since then the motor of coarse only handled abit over a year regular...
  4. P

    Gearbox help

    Hey guys! I have a W5M33 NRBE gearbox in my gsr, wondering if i can replace it with a W5M33 NRWE gearbox? i know nrbe has no lsd and nrwe has viscous lsd.. needing to replace my gearbox as synchros are gone. Thanks!
  5. oktoba

    4g15 - 4g93t conversion

    Hey guys I have a 1996 CE Lancer chilling in my driveway. I've converted the 4g15 over to a 4g93t. It's the lastest gen with the engine on the right side. This is my gearbox F5M421-F8A7-AQ2944. FWD. Now I'm not 100% sure whether it's a N/A 4g93 or 4g92 Mivec box... It all bolts up fine but...
  6. R

    Magazine info needed! 4G93T CD5A Upgrades

    Hey guys, my names Rene I am a contributing editor at NZ Performance Car Magazine. Every month I run a feature named 'Scrapyard Gains'. It's basically a feature on a lower spec performance car, which has the ability to be upgraded with stuff from the models above it. In the past I have featured...
  7. molemac

    (NSW) 1993 Lancer Gsr

    Hey Guys I am selling my 93 lancer gsr only done around 135k, really reliable car never had any problems drives smooth Car is running the orginal 4g93t FEATURES - Nardi steering wheel - enkei rpf01 wheels (16x7 front) and (16x8) rear - Amber corner lights - gfb blow off valve - blox...
  8. Smutt

    Forged 93 GSR priced today

    Turbo - $700 Garrett GT 3076 - 525 hp - essentially see below Garrett Gt3071 with 3076 wheels with 0.63 A/R on my 1.8 held 30psi all the way to 8800 This compressor map pushes up to 36psi (still in efficiency plot on graph) Evo 2 mechanical LSD rear diff - $500 Pwr water pump and fan and 10"...
  9. molemac

    TD05 16g on 4G93T

    Hey guys I have a 93 lancer cc gsr and I have recently brought a td05 16g and from what I have heard its a straight blot onto the 4g93t I was just wondering if anyone has had any experience with this conversion and would anything have to be custom made to fit the turbo and would I have to buy...
  10. 3VOLUTIONIST

    Rebuild 4G93T or look for a 63T?

    Looking into parts for 63's and 93's at the moment, it's damn near impossible to find anything for either motor online (Evo 3 and earlier 63t), and I'm trying to decide whether I put some money into the spare 93 that's oiled and glad wrapped in the shed, or look for a 63t from, well who knows...
  11. G

    Firing on 2 cyl - Crank angle/Top-Dead-Centre sensor troubleshooting

    Hi guys, My '93 Lancer GSR doesn't fire on two of the cylinders (2,3) and also won't start. I ruled out the following: - Fuel pump failure - Coil Pack failure (bought a replacement one and same problem) Checked the resistance on the coils and this was in range (12kOhm), so no shorted turns or...
Back
Top