stroker

4GTuner

Help Support 4GTuner:

  1. doo doo

    Would like your opinions on possible engine configurations for gsr

    Hey everyone It's become necessary to downsize my garage stash (keeping some bits for plays) over the next couple of months- I have 2 lancer gsr's that I'll be looking to move and a couple of different engine possibilities for them. I'm a bit stuck thinking about which combos to put in them...
  2. MDK87

    VR4 Parts

    GVR4 parts: Energy suspension bushes were bought from USA. Not all of them are available here. (New) Energy Suspension polyurethane (PU) rear upper and lower control arm and trailing arm bushing kit. Made for 1G DSM but the rear ends are the same. $100 (New) Energy Suspension PU front sway bar...
  3. E

    FS: CP forged piston kit (7-bolt 9:1 stroker OR LR)

    CP Piston kit for sale. Brand new in box with all paperwork. $750 ONO Specs are: Titan Motorsport design (1400HP) 7-bolt CR 9:1 85mm bore 88 mm stroke with 156 rods / 100nn stroke with 150mm rods Optional CP ceramic coated sides and top HD forging Has provision for +1mm bigger...
  4. E

    WTB: Bottom end parts for foged build (7 bolt)

    After forged components for a 7-bolt bottom end. Would prefer a kit but willing to buy separate components as well. At this stage I am looking at all options (standard, stroker, long rod) however do want higher compression pistons (min 9.5:1) and prefer max 85.5mm bore. Thanks Alex
  5. MDK87

    Tomei 2.3L 4G63 Parts Evo 1-9

    Evening lads. I have these 7 bolt parts for sale. All items brand new in boxes. Tomei 2.3L stroker kit: Tomei 86mm crank Tomei 86mm pistons/rings/pins Tomei 147mm H-beam rods Tomei MLS headgasket Tomei 280deg 11.5mm intake and exhaust camshafts Tomei solid lifters Tomei oversize intake and...
  6. E

    long rods with 100mm crank?

    Just doing a sanity check here, When running a 100mm crank in a 4g63, only standard length rods (150mm) can be used as the pistons will be too short with 156mm rods. Does this sound correct, or are there 'off-the-shelf' pistons to suit 100mm crank & 156mm rod in a 4g63? To my understanding...
  7. ENGINR

    SOLD! G4CS Block (2.4 litre 6-bolt)

    For Sale is my G4CS bare block. This the 6-bolt version from the Hyundai Sonata that will bolt up to an EVO/VR4 gearbox and I was searching high and low for one before I purchased this block from bazeng approximately 1.5 years ago. I had grand plans to rebuild it into a high revving 2.4litre...
Back
Top