ABS Light and handbrake light

[Hypo]

I have high pressure cleaned the engine bay and under the guards and these lights are now on. I have adequate fluid and I have removed both front sensors and cleaned them. What else can cause these to stay on?

I also disconnected the plug to the brake booster and this made no difference. Is there a way to reset the abs?

I need this resolved by next Saturday as it is the first track day of the year. Yes I still use ABS on the track and I wish to continue doing so.

On a separate note if anyone needs a small radiator overflow bottle a KC laser is the perfect donor and sits right above where the intercooler pipe goes through from the turbo.

 

[DOUGMO]

maybe check the plugs under/near the lhf guard where the abs modulator is, they may have some water in them?

 

[Hypo]

Checked cleaned and filled with wd40. There was no water present. I am guessing I am going to have to follow each wire back and see what I can find or hope it drys out.

 

[DOUGMO]

another thing to check maybe the front sensors?

 

[Hypo]

The ones on the hubs? I have removed both of them and cleaned them,

 

[DOUGMO]

yep, the hub ones, check the rings on the shafts are clean too, short of that Im out of ideas sorry luke

 

[EVO-00X]

Open the brake fluid reservoir lid and dangle the internal float up and down a few times, then check if the light is still on.
I know a similar thing happened to me once and I was too busy looking everywhere else for an answer.
I facepalmed myself afterwards

 

[Hypo]

I don't appear to have a float. Potentially it is located beneath the initial top of the reservoir.

 

[Hypo]

How do you test a abs sensor on this model lancer and what should the Ohm reading be?

Should I see power to the ABS sensor plug when the the car is at accessories or will it need to be going?

 

[Hypo]

Potentially found the issue. How long does the system take to reset?

 

[4piknup]

Disconnect abs module should do it... or battery for 20 min