AFM to turbo pipe...what have you used?

[kayarubin]

hey guys! just a question!

what size piping do u use between the AFM and the turbo??? i have measured the turbo inlet and its like 55-56 mil...

do i use 2.25 inch pipe between the turbo and AFM and then get a 55mil to 85mil silicone flare thinggy??

anyone done anythin different to this way?? if so do u have any pics u can post up?

cheers guys!

kaya.

 

[GVR40]

where u gettin 86mm from, 76mm is 3", why not put a silicon flare coming off the turbo 56-76mm and then work with 3" piping

 

[kayarubin]

its deffonately 86 mil mate!....could it have something to do with the AFM housing being diffreent?? its a jap spec RS model vr4....

i dunno what the hell is goin on either eh!... :roll:

anyone else got a 86 mil AFM hole?

cheers!

 

[GVR40]

i would still do the silicon step up at the turbo to 76mm then run 3" piping to the filter and another step up there to your 86mm

 

[WRCVR4]

Flare out a piece of exhaust pipe, then just use a straight piece of silicon hose, thats how mine is done (Was done in Darwin even :wink: )

 

[kayarubin]

i think theres a little less room in the nimbus comapred to the VR4 between the two holes..... but ill look into the exhaust pipe thing! im sure it wouldnt be that hard

cheers!