have a read boys
http://www.wolfems.com/content/view/43/
-sequencial ignition
-sequencial injection
-wide band lambda
-dual memory system
-16 outputs
-6 multicontroller outputs
-(GPO and MCO functions can support VTEC/VVT, NOS, Water Spray, Stepper Motor, Emissions Control, Idle Up, Warning Lights, and any other additional devices required.)
-idle speed
-closed loop control
-electronic boost controll
-turbo timer control
-shiftlight function (6 stages)
-security pin code
-30 psi internal map sensor
-3d software
-full live datalogging
-virtual gauges
-Advanced high-detail Fuel, Ignition and Control mapping systems, 2048 points at 125rpm steps with Easy Tuning modes.
-and much more to list
The kit contains:
1 x Wolf V500 ECU
1 x Wolf V500 Main Loom
1 x Wolf V500 Input Trigger Loom
1 x PC Software and Help File CD
1 x PC Serial Cable
1 x Set of ECU Mounting Brackets
1 x Warranty Card
2 x Wolf Sticker
HALTECH E6X:
- Up to 4 fuel and 4 ignition channels (internal toggle)
-4 dedicated PWM outputs
-1 auxiliary input
-1 auxiliary output (tacho output)
-Dedicated closed loop idle control
-Dedicated closed loop O2 correction
-8 injector drivers as standard equipment
-An internal barometric pressure sensor
-New RA8 reluctor adaptor
-Rev Limiter
-Deceleration fuel cut
-Datalogging to laptop
-Flatshift
-Dual Mapping
-Single Distributor
-High boost software (up to 65 pounds with optional MAP sensor)
-RPM Range increments 500/1000 rpm
Electronic Boost Bleed Valve
*electronic boost control *thermofan *anti-lag *VTEC
*engine control relay *NOS enable *BAC valve *shiftlight
MAP Sensor
*intercooler fan *turbo timer *stall saver *air con
*aux. fuel pump *staging signal *dual intake valve
(not all functions are available at the same time)
http://www.haltech.com.au/downloads/e6x_spec.pdf
AUTRONIC SM2
# Sequential operation for 2 to 8 cylinder engines.
# Eight injector ouputs.
# Four ignition ouputs (ignition expander available for up to 8 outputs)
# 3D fuel and Ignition maps.
# User defined up to 32 RPM and 16 Load sites = 512 sites.
# Eight auxiliary outputs other than fuel pump control.
# Auxiliary outputs can be defined for boost control, nitrous oxide, staged
# injectors, camshaft timing, AC, fan control, idle valve etc...
# Traction Control.
# Flat Shift. (ver 1.92 & 1.93)
# Launch Control. (ver 1.93)
# Anti-Lag.
# Data Logging.
# Available with high current drivers if required.
# AutoTune option available.
# Compatible with Motec Dash.
http://www.autronic.com/page_files/sm2_kit.htm
judge for yourself guys...
