Ball joint boot part number

[Widget]

Hi im after two ball joint boots for 1993 gsr. Does any1 know the part number and were to get around perth or cheep off the net. I may have to buy the while ball joint if i cant source just the boot so part number for that would b gr8 as well.
Thanx guys.

 

[clone]

mate it would be cheaper to replace with just aftermarket balljoints

 

[khubner1]

MB176047 cover fr susp lwr arm ball joint

 

[Widget]

MB176047 cover fr susp lwr arm ball joint

Thanx do u have number 4 ball joint or rod end as pulld other side out today and its rooted

 

[khubner1]

are we talking sterring here? if so
gsr/evo tie rod end MB912076 complete assembly
parts
split pin MF472054
crown nut MB122128
rubber boot MB616023

all appear to come in pairs

 

[Widget]

are we talking sterring here? if so
gsr/evo tie rod end MB912076 complete assembly
parts
split pin MF472054
crown nut MB122128
rubber boot MB616023

all appear to come in pairs

Was originally talking suspension but also do need tie rod end as well. Wrote last message in a rush sorry and did not explain very well. So thanks a heap.

 

[khubner1]

There doesn't appear to be a part number for just the ball joint looks like to get that you need a complete lca

 

[4piknup]

Probably 4 good ones on my parts car.
I have a look when im going past on thurs. Im in perth too.

I would only have boots. As the car was crashed and I wouldnt sell the ball joints in case they are damaged

 

[evo-gsr]

You do need to buy the whole lower control arm..
There was a thread somewhere on shimming the control arm or similar.

 

[philsth]

I replaced both the complete ball joints in my GSR with aftermaket ones (Repco), they just pressed in.

Cheers

 

[evo-gsr]

Well there you go. Do you happen to have the part numbers...?

 

[Widget]

Thanx guys. Went in and orderd parts 2 day. Will b looking at rear end in wked hopfuly wont need to replace anything. But I dout it by the way things r going so far, every thing looks to be the origanail stuff, 20 years old

 

[Widget]

Probably 4 good ones on my parts car.
I have a look when im going past on thurs. Im in perth too.

I would only have boots. As the car was crashed and I wouldnt sell the ball joints in case they are damaged

All gud now m8. Need float switch off fuel pump cradles if u wanna let them go, or whole cradle with pump. Pm me.

 

[EV0300]

anyone know how to get that stupid snap ring off the ball joint, it doesnt have holes in it like most ive seen :s

 

[4piknup]

I dont think there is one. Its just a step to know when its fully home.

 

[EV0300]

yeah theres one there it sits just under the boot, you have to sort of lift the edge of it to see the ring but it looks like its there to hold it in place

 

[4piknup]

I put this pic up last night just after my post and I saw it there. But its gone now.
Anyway, im sure (90%) this is a gsr balljoint. I dont think it shows the bit you are talking about tho