Boost leak - injectors

[xjokux]

I'm just fixing up a few boost leaks around the bay and notice two injectors are leaking air. I've already got new seals on all four. Are there any further way to improved a better sealed surface?

 

[xjokux]

Dis reagard this post - My inlet manifolds bolts were loose. Though I was pretty sure I did them tight.

Would a new magus heat gasket loosen the bolts after its been heated up requiring further tightening?

 

[4piknup]

Its been a long time since we had to retention head gaskets, but I still check them and always get a small turn on each the first time.
I check them whenever rocker cover is off, too easy with mitsi as you don't need to touch the cams.

 

[brisvr4]

Mine never has, Jono was talking about a heat barrier gasket, not head!

 

[4piknup]

Yea, your right, sorry guys. facepalm

 

[bazeng]

I found my cars needed to re torque the manifold after a good few heat cycles.

 

[JETGSR]

yep! i'm forever nipping mine up.
but i don't have a very thick flange on my intake.