Brembo Rear Brackets

[(2much)]

Hey Guys,

I have been talking with techsport, as i want to get a set of these rear brembo brackets.

they are not currently available, and he will not be commisioning any new ones till he has a couple of people locked in..

anyway, as i am one of a couple, i only need another person interested to get this underway...

dont get stuck in the future, wanting to do this mod, and then finding that the parts aren't available.. LOCK IN YOUR AVAILIBILITY....

PM me if your interseted, the brackets are $550 for the pair.

I'm ready now....

 

[htgsr]

When I got my front ones made up I took my hubs rotors an callipers to a local engineer (he used to make all our brake bedding dog bones) an he made some alloy ones an it was a hell of a lot cheaper than that, might be worth looking into if you don't get any interest on this line

 

[to4garret]

Rob at racefab.co.nz does them,

$350NZD, instock.

http://racefab.co.nz/index.htm bottom of the page.

HTH!

 

[(2much)]

that is a bit cheaper, but i know that the techsport ones are tried and tested, they are already on multiple cars on this forum, i would like to get on board with their product.

thanks guys, im worried about getting a one off component to connect the caliper to my kunckle, it's a braking component afterall.

 

[htgsr]

Rob at racefab.co.nz does them,

$350NZD, instock.

http://racefab.co.nz/index.htm bottom of the page.

HTH!

Even better! that's roughly half what you were quoted with the exchange rate!!

Fair enough about the one off, i have tried an tested my guys work well beyond what ill ever need so was happy to run them, but you need to be confident in what you go with

 

[to4garret]

Rob's work is on hundreds of cars, his adapters are also tried and tested, if you look at the picture there are 5 sets, these are not one off components.

but do what you want, I'm all for supporting local companies

 

[htgsr]

Isn't Racefab where DOUGMO gets heaps of his gear from? What are the ones your looking at from techsport going to be made from?

 

[(2much)]

Thats a good question, george has heaps of racefab parts, but he has techsport brackets, im just going with what i know.

 

[DOUGMO]

I have the techsport brackets, I purchased them about 2 years ago.

They are machined out of one piece of material and are very nice.

I also have pretty much the whole catalogue of parts that Rob from Racefab sells for earlies.

sump
inlet manifold
exhaust manifold
front crossmember
rear crossmember
front control arms

I even have a 3rd crossmember on the way soon!!!!! (north south)

 

[Velocity Racing]

what rotors are you running for the rear brembo's? just Evo 5-9 rotors re-drilled to 4x114.3??

 

[(2much)]

i have the brembo evo 8 300mm 5stud, with 5 stud hub, i just need to organise these brackets and i'll be on the way...

george has the same setup as what i am trying to achieve, and to be honest, i'm comfortable following in his foot steps.