Cb lancer disk brake specs

[Gianni]

Anyone got specs for cb lancer front brake disk specs
Mainly thickness of brand new and thickness of the minimum

 

[Benzo4gT]

I did an awesome post about thickness new and runout, then realised I was looking at CC lancer stuff, now I can only edit the post and look like a total knob, but any way, here is a link to a Delco brake parts site, measure your own discs and see if the total diameter is the same as a CC, bear in mind there are 2 types, 1.5ltr which is a solid disc, and a 1.5 wagon/1.8 coupe/sedan which is ventilated, oh shit, it's getting confusing! Anyway, if you measure yours and compare them to the CC you might have some luck, sorry if it doesn't help, I have a magical talent to make normal stuff complex

http://www.acdelco.com.au/PDFs/Catalogue_ACDelco_Rotors.pdf

 

[Gianni]

Yeah cb are totally different to the cc. The rotor is slotted but looks like its built into the hub some how

 

[DOUGMO]

is it a gl or gsr?

 

[Gianni]

Gsr man

 

[DOUGMO]

256mm x 24mm for gsr, min thickness 22.4mm

 

[Gianni]

Alright cheers thanks man. Btw are they hard to replace. It's a weird set up

 

[DOUGMO]

you have to pull off the centre hub/bearing bolt as the disk is bolted to the back of the hub

 

[trq-str]

Press fit?

if so, go use Adams press.

 

[Gianni]

Yep. What's this mean. I have to do hubs as well

 

[DOUGMO]

just use it as an opportunity to clean and regrease the front bearings

 

[4piknup]

Lube at every opportunity....

 

[Gianni]

It's for roady. I measured then at 22.7 but the guy says they are 22.4 so not road worthy. Grr.
Also there is a temp sender not being used on top of the water tap and failed it because of that. This engine doesn't actually Italian that sensor

 

[Gianni]

It's for roady. I measured then at 22.7 but the guy says they are 22.4 so not road worthy. Grr.
Also there is a temp sender not being used on top of the water tap and failed it because of that. This engine doesn't actually utalise that sensor

 

[JayRome]

I have changed CB GSR disc's while on the car.... so its doable without a press...

And you posted this in the wrong section