Crank shaft for Evolution 1-3..please help!!

[USO-GSR]

Looking for the best place to find an aftermarket crank shaft (preferably forged) to go with my forged Evo 3 motor..can anyone be of any help??

 

[DOUGMO]

plenty out there mate, evo 1-9 aftermarket cranks are all the same if that helps.

 

[BMGTZ]

the stock cranks are pretty good fro HP....unless you want a stroker I wouldn't change it

 

[JETGSR]

just get your stock one balanced and cleaned up
Just remember to seat the thrust bearings correctly before final assembly and make sure you size up the bigends of your rods for
correct clearances or you will have thrust bearing failure (crank walk)
Are you changing rods too??

 

[EVOCPE]

If you worried that much, after getting it checked over you can always get the crank nitrated

 

[USO-GSR]

Well the problem is i just bought a forged evo 3 motor from a mate to chuck into my gsr. All he's told me was that it needs a new crankshaft because the old one cracked..

 

[CLuTZ]

Sounds like you need more than a crank. I'd get someone to dissassemble and inspect the entire bottom end

 

[4piknup]

They run 700hp on a stock 64/63 crank. Thats getting towards 400awkw

 

[evo-gsr]

If your getting a new forged crank..budget around $1000 depending on what you get

 

[USO-GSR]

Yeah i figure i would be needing more than just a crank so ive just been reading through the forum for any other parts etc that i mite need..

 

[BMGTZ]

bring bottom end to me and i will have a quick look for you..

what is you name?

 

[Evolese92]

bring bottom end to me and i will have a quick look for you..

what is you name?

his names Alfie, I'm sure you've met him brian

 

[4piknup]

Is he your brother evolese?

 

[Evolese92]

Is he your brother evolese?

Yeah one of them lol as you can see were all newbies haha he drives a green evo 3 styled gsr you might've seen it on gumtree a few months back?

 

[BMGTZ]

tell him bring it round.....also tell him I will give an opinion...my opinion. That is do it right...do it once...DONT cut corners...do it yourself....if you cant do it yourself make sure the person doing it KNOWS WHAT THE FUxK they are doing.

where did the engine come from?

I will look at it with the sump off .....so take that off before you come

 

[mymidlifecrisis]

Yeah one of them lol as you can see were all newbies haha he drives a green evo 3 styled gsr you might've seen it on gumtree a few months back?

Seen this car and it's driver with the Don King haircut in Middle Swan the other day ...perhaps?