Evo 2/3 ball joint nut

[Craig_CD9A]

Does anyone know the nut size and thread pitch for the nut used on the front lower control arm ball joint?
I'm going to have to get a die run over the ball joints thread as it has been damaged in transit by the looks of it.

Cheers
Craig.

 

[Jonson]

Why not just replace the ball joint Craig? They aren't expensive, and that way you know they are in good cond. when you install the arm. I can help if need be, just get the arms and joints to me.

 

[Craig_CD9A]

That would be the best thing to do, for sure, but.. I don't think it is possible to replace the ball joints in these control arms?

If I can't have them replaced with new ball joints or repaired, then I'm going to send them back. Which is what I should have done in the first place, as the shop that i bought them from told me the ball joint was in good condition when I asked about it specifically!

 

[wesleyong]

Pretty sure you just get them pressed in/out at a suspension place!

 

[wesleyong]

...Or smack the heck out of it with a hammer.... It's scary!