Facelift/ausspec throttle body onto Prefacelift motor

[tharaka]

Hey guys
Is it possible to bolt up a facelift, ausspec or even an evo throttle body onto my prefacelift motor

i just want to fix the idle, because isc's arent available for the pre-facelifts anymore

 

[Entaran]

I think it's just a matter of plugs to be honest.

There's no actual difference in TB's.

 

[tharaka]

I think it's just a matter of plugs to be honest.

There's no actual difference in TB's.

i have a wire in tps

so i'll need to get a plug or something
or just get that wired in


i just wanted to know if theres any voltage differences or anything that will fry my ecu

 

[Entaran]

nope.

Easiest thing would be to give it to an autoelec and say fix.

There's NO difference in voltages. Just one has 3 and the other has 4 pins from memory. or maybe 2 and 3 :/

 

[AUSVR4]

My aus spec was a 3 wire TPS with separate ISC. With the EVO TB the wire simply needed soldering into the 4th pin

 

[tharaka]

My aus spec was a 3 wire TPS with separate ISC. With the EVO TB the wire simply needed soldering into the 4th pin

do you still have your old aus spec tb?

 

[AUSVR4]

Yes I believe I do

 

[tharaka]

INteresting

check your pms

 

[matress]

i think the later models have a 4 wire tps whereas the earlier ones have a 3 wire.

chris meek usually has the 4 wire ones if you need one.

 

[tharaka]

i think the later models have a 4 wire tps whereas the earlier ones have a 3 wire.

chris meek usually has the 4 wire ones if you need one.

yeah
thats the opposite to the one i have
i spoke to him about it a while ago