Found a source for EVO3 MT tranny! AT to MT Swap! Need your advice!

[chariotgthk]

Guys you know I have been looking for a Evo3 MT tranny for a long time finally I seems to have found one today!

But the set would only comes with gearbox + flywheel and clutch then no more (No harness & MT ECU!)

What I have is a MT throttle body for MT EVO 3

What are the other parts I needed? Is it an issue if I only fit in a MT gearbox without changing the sensors, ecu, harness, center diff and final gear?

Many thanks!

 

[dj_konix]

Pedals!

 

[JETGSR]

E3 transfer is different to std transfer too. must match E3 box

clutch master cyl

clutch slave
probably heaps when you start looking into it.

 

[syco_rvr]

E3 transfer is different to std transfer too. must match E3 box

clutch master cyl

clutch slave
probably heaps when you start looking into it.

on top of matching the E3 Box if you change the transfer case you will most likely need to change Rear Diff also to make sure the Ratio's are all the same, even if you had a RVR MT its likely these would need changing.

things you'll also need are the selector cables, shifter and shifter cradle,

as for the ECU would be advised to run factory MT one harness should be the same though.

if you were in NZ got the whole conversion for you on my drive

 

[4piknup]

as far as i know, the auto transfer case wont even bolt onto the manual box.

1st dibs on all auto bits removed. freight will be a killer, but i better get in defore aldo. lol

(carry on luggage?)