FS Under car surgetank + Bosch pump

4GTuner

Help Support 4GTuner:

jake

Donating Members
Joined
Dec 20, 2008
Messages
291
Location
Sunshine Coast
Item:
Under car surgetank + Bosch pump.
Item Condition:
Used however Good working condition.
Price:
Price drop from $200 to SOLD Re listed do to Time waiter from another forum +postage
Extra Info:
-Aluminum Surge Tank, approximate 1.5L,installed under car,brass push on fittings, recently polished.
-Bosch 0 580 254 910 Fuel Pump, 72.5 PSI, Flow rate of 130 liters per hour,(from Bosch website),recently polished.
-Bosch Fuel Pump Red Mounting Bracket.
This is my old setup, I believe it hasn't done to many miles, as the cars been off the road for a few years.
Selling do to up grading and E85 Conversion.
Note: When I was removing the unit the Positive terminal was cross threaded when installed on (previous owner) Refer to Pic. I have tested and the pump works fine and shouldn't be to hard to re-thread/fix and does not affect the power to the pump.
Location:
Buderim, Sunshine Coast.
Preferred Contact Method:
-PM me (my msgs are linked to my emails and phone)
-0413477315 ring or txt (please no numbers on private)
If you would like to have a look in person or want more pics or have any more questions feel free to ask.
Pictures:

setup1.jpg


Setup3.jpg


Setup4.jpg


Setup5.jpg


This is the first of a few parts from my old setup that I'm selling and more parts will be come available as I pull them off the car including,
-5 stud conversion with 3000gt front and rear brakes
-Bolt on Genuine Garret GT2860 RS turbo setup SOLD
 
I have resisted this due to a time waster from another forum

Price drop from $200 to $150 Re listed + postage

how much will you want for the 5 stud parts?

Basically I have 5 stud conversion to suit cc gsr and matching 3000gt brake conversion to suite. Parts listed below.
  • TR/TS Magna 4 cylinder front hubs, They match gsr and evo front drive shafts and bolt on the gsr/evo control arms and strut and tie rod ends. 5/114
  • Redrilled cc gsr rear hubs. 5/114
  • Custom Front 3000gt 4 pot caliper brake adapter brackets
  • Custom Rear 3000gt 2 post caliper brake adapter brackets
  • 3000gt 4 pot front calipers, freshly painted Red
  • 3000gt 2 pot rear calipers, freshly rebuilt and painted red
  • Brand new Bendix ultimate pads Front
  • Brand new Bendix pads Rear
  • 300mm 3000gt Front Brake Rotors, freshly machined,
  • 280mm 3000gt rear Brake Rotors, freshly machined
  • Mitsubishi Magna TR TS drums handbrake assembly (I bought to do a drum handbrake conversion however never got around to it but still have the it there and will include it as with a bit of modification it should fit on the gsr rear control arms)
  • 3000gt Brake master cylinder, Recently rebuilt
This is a 5 stud and 3000gt brake kit to suite with custom brackets so id really like to sell the whole setup together as the custom brackets I had made up wouldn't fit the 4 stud hubs.

When I stated to run the 3000gt rear brake calipers I didn't have a rear handbrake any more as the gsr factory are are though the caliper so I modified a hydraulic handbrake setup to use, I started to modify a magna rear drum to suite to finish off but ended doing a full brembo and evo 4 hub conversion.

Basically the Kit is 98% complete, would just need front wheel bearings in the magna hubs.Front and rear Brake hoses, a brake proportioning valve for brake bias and some sort of handbrake finished


I'm looking around $800-$1000 ONO for the lot so essentially for big brake bolt on conversion kit and 5 stud conversion kit, + shipping
 
how much for just the rears?

What part of the rears were you looking for?

All the evo 4 rears in the gsr are the evo 4 hubs pushed into the gsr arms and custom braket that is getting fabricated tomorrow and uses the evo 4 drum brake

have a read of that for more info

http://www.4gtuner.com/topic/15800-vr4-powered-gsr/
 
ive done my 5 stud conversion on the front and havent got around to doing the rears so how much would you sell for just the rears
 

Latest posts

Back
Top