FS: Water/meth injection setup

4GTuner

Help Support 4GTuner:

brisvr4

Member
Joined
Apr 2, 2005
Messages
4,486
Location
Brisbane - Southside
Guys,
I am looking to part with my Water / Meth injection setup as I will not need it with the new setup.
The setup will include a Labonte motorsports fail-safe setup.
I'll post links to both kits below.
The water injection side of things first.
It is a Coolingmist stage 1 kit + tank. Inlcluded are 1 x 370cc injector and 1 x M10 ( 630cc ) labonte injector.
I was using the M10 until recently.

The failsafe setup basically forces your car to run at wastegate pressure until it senses a flow of liquid through it. If anything fails whilst you are under boost it activates a solenoid which reverts back to wastegate pressure again which should save you from a massive lean condition. ( clogged injector, run out of water etc )

I would only be looking to sell this as a complete kit.

I am looking for $400 for the lot.
This setup cost me well over $500 and is worth every dollar if you want to run decent boost levels and still have a nice cool intake charge!

Here is a couple of links to the 2 websites....
http://www.labontemotorsports.com/store/ccp0-prodshow/IFS-30C.html
http://www.labontemotorsports.com/store/ccp0-prodshow/NOZ.html
http://www.coolingmist.com/detailmain.aspx?pid=01250TBF
 
offer is still there tim if you want it, we can even exchange throttle elbows so you don't have to weld up the hole in yours
 
Thats cool Craig, still thinking about it mate. I do need a bung in my TB elbow though for the GM air temp sensor :)

BTW Dsmlink V3 is pretty complex too !
 
Back
Top