slow ute
Well-Known Member
Item:1993 Mitsubishi VR4
Location: Townsville
Item Condition Almost new motor, Interior Good, Body average
Reason for selling: Need boat bits
Price and price conditions: $5000 ono
Kilometers: 150xxx
Time to move on. Need some new bits for the boat and dont have time any more.
Motor (this is the good bit)
* CP forged piston's and rings
* 9:1 comp ratio
* Eagle forged rods
* Acl Race Series Bearings
* Arp main and head studs
* Cometic mls head gasket and full Cometic gasket kit
* Crank scrapper
* All balanced
* Crower 272 cams
* Crower springs
* titanium retainers
* 3g lifters
* Tomei Adjustable Cam Gear
* Power house enterprise timing belt
* all new idlers and water pump
* balance shafts removed
* front mount oil cooler.
* new genuine Big 16g and 2.5inc divorce dump pipe,
* 3in dump back with magna flow cat, 3in resonator and no name muffler
* PWR water to air 600hp barrel with custom end tanks
* Greddy blow off valve full plumb back
* 3in stainless intake with air alloy air box and drift pod.
* Walbro 255 intank
* 560cc Evo 8 injectors just been cleaned
* AEM fuel pressure reg and guage
* Speed flow fittings
* brand new Adaptronic e420c with 3bar map sensor
* Coil over plug ignition
* EMS Ignitor
* Gizzmo electronic boost controller.
motor has only done about 5000 ks since rebuild 3 years ago. Have some of the receipts for the engine.
For some reason the clutch wont engage. no idea why will see if i can fix it. *clutch fixed. just needed to be bleed properly*
Interior
Seats in good nic appart from the passener seat has a slight stain.
All electrics work well
Tint in good condition
Carpet ok.
Stereo works
Splits in front and rear.
Exterior
Front passenger has dint but have a new guard
Has a deep scratch that runs accross the bonnet, guard and drivers door
has other scratches as well. paint isnt too bad
rims have gutter rash and tyres arnt much chop
has slotted rotors and new pads. front and rear.
$6000 ono
no rego
will cost you $300 to ship it to brissy
cheers
mick
Location: Townsville
Item Condition Almost new motor, Interior Good, Body average
Reason for selling: Need boat bits
Price and price conditions: $5000 ono
Kilometers: 150xxx
Time to move on. Need some new bits for the boat and dont have time any more.
Motor (this is the good bit)
* CP forged piston's and rings
* 9:1 comp ratio
* Eagle forged rods
* Acl Race Series Bearings
* Arp main and head studs
* Cometic mls head gasket and full Cometic gasket kit
* Crank scrapper
* All balanced
* Crower 272 cams
* Crower springs
* titanium retainers
* 3g lifters
* Tomei Adjustable Cam Gear
* Power house enterprise timing belt
* all new idlers and water pump
* balance shafts removed
* front mount oil cooler.
* new genuine Big 16g and 2.5inc divorce dump pipe,
* 3in dump back with magna flow cat, 3in resonator and no name muffler
* PWR water to air 600hp barrel with custom end tanks
* Greddy blow off valve full plumb back
* 3in stainless intake with air alloy air box and drift pod.
* Walbro 255 intank
* 560cc Evo 8 injectors just been cleaned
* AEM fuel pressure reg and guage
* Speed flow fittings
* brand new Adaptronic e420c with 3bar map sensor
* Coil over plug ignition
* EMS Ignitor
* Gizzmo electronic boost controller.
motor has only done about 5000 ks since rebuild 3 years ago. Have some of the receipts for the engine.
For some reason the clutch wont engage. no idea why will see if i can fix it. *clutch fixed. just needed to be bleed properly*
Interior
Seats in good nic appart from the passener seat has a slight stain.
All electrics work well
Tint in good condition
Carpet ok.
Stereo works
Splits in front and rear.
Exterior
Front passenger has dint but have a new guard
Has a deep scratch that runs accross the bonnet, guard and drivers door
has other scratches as well. paint isnt too bad
rims have gutter rash and tyres arnt much chop
has slotted rotors and new pads. front and rear.
$6000 ono
no rego
will cost you $300 to ship it to brissy
cheers
mick
