Gizzmo ds2

[Qik-1.8]

hey guys wondering if anyone can help me out
i have a gizzmo carbon fiber shift light ds2, and it has 3 wires to connect. im putting it into a 93 gsr Cluster

RED WIRE: positive 12v
BLUE WIRE: Negative
GREEN WIRE: Connect onto the ecu taco wire or ecu igniter trigger wire

now i know it can be wired onto the back of the cluster anyone can show me what ones i should plug into???

http://www.gizzmoelectronics.com/pdf/GIZZMO%20DSII%20Instruction%20PDF%20Ver1.01.pdf

regards
Grant

 

[HYP04]

hey guys wondering if anyone can help me out
i have a gizzmo carbon fiber shift light ds2, and it has 3 wires to connect. im putting it into a 93 gsr Cluster

RED WIRE: positive 12v
BLUE WIRE: Negative
GREEN WIRE: Connect onto the ecu taco wire or ecu igniter trigger wire

now i know it can be wired onto the back of the cluster anyone can show me what ones i should plug into???

http://www.gizzmoelectronics.com/pdf/GIZZMO%20DSII%20Instruction%20PDF%20Ver1.01.pdf

regards
Grant

The loom supplied is long enough to take to the ECU, thats where i had connected all 3 wire.
Otherwise i have seen power taken from the 12v assessories and like your doing behind the cluster. Im confident its the white wire behind the cluster.
I could be wrong but i used the same pin outs that as EVO for the Tacho when i connected a Apexi revspeed meter to my old GSR
Below is a link in the EVO topics
http://www.mediafire.com/?2guqyy3wl2y
Otherwise i referenced to the Apexi manual site.
You may need to update your font to japan when requested but will appear in english afterwards. but it it doesnt, its most likely M2-a
http://www.apexi-usa.com/content/pdf6139.pdf

Down the page is a diagram also.
http://www.4gtuner.com/index.php?/topic/4437-ecu-wiring-diagram/

 

[Qik-1.8]

a mate had his all wired into the rear of the cluster where the screws are and i am not sure which ones to connect to

 

[HYP04]

I checked all the diagrams i have, and up till the Evo 4 the Tacho wire was White. Im not sure which plug on the back of the cluster it is.

 

[Qik-1.8]

Does the gsr have a rpm or taco screw in the back of the cluster. Is it called rsw???

 

[HYP04]

Does the gsr have a rpm or taco screw in the back of the cluster. Is it called rsw???

RSW is the speed signal. Which connects to the centre pin/spade terminal on the right plug in this pic. Im sure that is a yellow cable aswell.

 

[Qik-1.8]

Does that tm screw mean taco meter???

 

[HYP04]

Does that tm screw mean taco meter???

Does the circuit run to a pin coressponding with a white wire?