GOOD Gearbox place in perth?

[milkandoj]

Anyone got suggestions for known good gearbox rebuilding place in Perth?
I got the box stripped down and want to change over 3rd gear syncro but i don’t have a press to get the gears off the shaft. Was thinking to get somewhere just swap that over, im putting it back together.

 

[4piknup]

bring the shaft around to my place and i will do it sunday. i in kenwick. you may need to get a new bearing as you gotta pull them by the needles and i broke the race on mine pulling it off. i even have a new synchro here. i got puller and press.
that driveline spares mob in belmont has bearings on the shelf tomorrow

 

[brisvr4]

You shouldn't need to replace the bearing on that end of he shaft if you are careful.
I usually just press off the spacer looking bit then pull the circlip off ( pretty sure it's hidden on top of the bearing ).
If you have a decent press you can press off 3rd and 4th together by just putting your bearing splitter under 3rd. Makes life a lot easier that way!

 

[4piknup]

i cant recall which bearing it is. its the input shaft one under 5th gear isnt it? i know that there was 2 that i damaged.
your a bugger tim, i guna have to pull the manual and look...

yep i see it. that one i damaged. if i did it like tim says it would be fine and reusable. i wasnt worried as i was replacing it anyway
my press is large enough tol push 3rd and 4th together, no worries. and easier than using the puller as well.
thanks for the tip tim