hyper gear with evo8 jdm ecu

[hyper gear]

How do i log AEM?

 

[hyper gear]

I have map sensor connected to pin 92, so is no problem there
i can log that. to connect aem i need to know wich pin i can use
any advise?

 

[BYBY5L]

Sorry bud not quite sure what ya meaning? What exactly did you wanna log? Air fuel or something

 

[BYBY5L]

check this link out might help ya,

http://m.evolutionm.net/showthread.php?t=302895

 

[hyper gear]

I wanna log AFR by using AEM WB02 (with evoscan), so i need to know wich pin on ecu i can use.

 

[BYBY5L]

i know pin 85 is the obdII on the 3 plug and diagnostics is 100
and i think its 79 ya want on the 4 plug, some one else can verify/ correct me if its wrong,
wish i could be more help bud

 

[hyper gear]

I didnt have any luck with pinouts yet

 

[4piknup]

Pin 75?

http://m.evolutionm.net/showthread.php?t=491918in

 

[khubner1]

yeah pin 75 seems like the best option that's the pin for the secondary o2 sensor 76 is the pin for the primary o2 sensor (ie pre and post cat)

 

[BYBY5L]

ooh shit i meant 76 not 79 fat fingers and phones dont mix, but yea after reading the link above it Does make more sense to do it off the rear lamda or 75,

 

[hyper gear]

Thanks boys,
ill try pin 76 and c how it goes.

 

[vr401]

Alex,
just swap your boost logging input wire once you have your desired boost set with your AEM logging input wire mate . You don't need your boost logged at all times. There is always a boost gauge to monitor.

 

[vr401]

BTW
once you swap them don't forget to change your evoscan formula