Looking for oil pump
- Thread starter WEB
- Start date
Help Support 4GTuner:
3zercrowd
Donating Member
Im on it.....Ill get an answer for you as soon as I can
Or an alternate aftermarket Japanese made one.
Last one I installed on a motor had a hairline crack in it that leaked. It was in the same line as a casting line. Bit of a shit job to replace AFTER the engine is put back together.
Its also VERY important to spray each side of the gasket with a light coat of hylomar spray, place the oil pump on and torque all the bolts up at a lower setting first, followed by its recommended torque setting second. They are too easy to crack if you dont get it right, or know which holes you are supposed to put the bolts into
Last one I installed on a motor had a hairline crack in it that leaked. It was in the same line as a casting line. Bit of a shit job to replace AFTER the engine is put back together.
Its also VERY important to spray each side of the gasket with a light coat of hylomar spray, place the oil pump on and torque all the bolts up at a lower setting first, followed by its recommended torque setting second. They are too easy to crack if you dont get it right, or know which holes you are supposed to put the bolts into
Entaran
Well-Known Member
On the singlecam 63 I assembled for fun last week I looked at the oil pump casing and the block, figured out where the threads were (which holes have bolts) and marked the casing with a paint pen. Made it easier to sort out when you couldn't see the block anymore!
