manifold vacum lines

[croket]

I have the aus spec manifold on my vr4 but it only has one vacum outlet and its running the my fpr bov and boost sensor for the avcr. Ive deleted the pvc valve and still have the opening in the manifold open , but blocked it with a hose with a bolt in it, my question is can i use that opening for my bov and boost sensor as im not comfortable running all three off the one opening. Im planning on tapping a couple of lines into the manifold but if i dont have to that would be great.

 

[turbovr4]

I just recently changed my Jspec manifold over to an Aus spec inlet manifold on my Eterna. I removed the two Allen key grub screws at each end of the manifold just under the plenum chamber, This is basically a casting tube for the vacuum. Then I then screwed in some 1/4 BSP vacuum fittings(from memory) and even a tee piece to give me three extra vacuum points.

 

[croket]

Nice , thanks mate ill suss that out for sure beats drilling and tapping into the manifold .