Measurement please?

[VR42LT]

Can some please measure and tell me what the measurements are between the mounting pins on the top and bottom of the radiator. As i popped the radiator in my nimbus am it looks like a evo 1.2.3. might be the same.

Thanks guys

 

[evo-gsr]

Its a bit hard to get exact measurement....but my Evo measures approx 440mm. Thats height of radiator not including the locator pins.

 

[evo-gsr]

Length is approx 685mm
And thickness is approx 50mm

 

[VR42LT]

Cheers that helps too but im after the pin to pin measurement for mounting. Sorry if i was unclear.

 

[VR42LT]

Horizontally

 

[VR42LT]

My 3yo daughter does better finger paintings than this lol.



And the bottom aswell please.

 

[evo-gsr]

One sec....but I wont be able to get the bottom one exact...will be approx.....only the top.
Cars locked in garage and too low to get underneath it.

 

[evo-gsr]

Centre of pin to center of pin on the top (horizontal) is approx 630mm

 

[evo-gsr]

Bottom measurement by my calcs is around the 350mm mark

 

[evo-gsr]

The mounting points for the evo rad are the same as GSR as well as any CC Lancer shape. Although the non turbo rads are a lot thinner in comparison.

 

[VR42LT]

Anyone got the bottom measurement?

 

[evo-gsr]

Like I said above.....approx 350mm.....I found the lower mounts and drew a line straight up from them to the top tank.

 

[VR42LT]

Ok thanks mate appreciate it.

 

[evo-gsr]

Your welcome Wade.

 

[BYBY5L]

A bloke on here had a koyo evo 3 radiator in his rvr, last I heard he popped the engine and was parting it out, so doubt hes on here still,
I have a couple of gsr radiators if ya need more exact numbers

 

[unhuman]

I have an aftermarket alloy evo I-III radiator in the cupboard ready to go in the car. Top pins are 630mm as per above, bottom is 400mm.

Note I haven't actually test fitted it in the car, but i assume it's correct.

 

[VR42LT]

Awesome thanks guys its fits the nimbus. Check my members ride thread