NZ new guy

[Kanos]

Hi all!
I'm from New Zealand, recently bought a CD5A Gsr which was quite cheap which is need of a lot of love haha.
Came with decent mags, BC gold adjustable suspension, braided brake lines, front and rear strut bars, and a few other goodies. :thumbsup:
Bad things are panel work and a lot of engine issues :thumbsdown:

Which section is the best place to ask in regards to upgrades? I have bought a few things but need some tech advise. Sorry if it's obvious haha I don't use forums much.

Cheers all!
Kanos

 

[evo-gsr]

Welcome mate....Theres a dedicated technical section for any tech questions you may have and plenty of people on here to answer too!!

See here....http://www.4gtuner.com/forum/19-evolution-1-3-cc-gsr-technical/

 

[Kanos]

Thanks heaps man!

 

[4piknup]

Careful in there boss, you will end up stuck in there for days, there is so much good stuff to find. Any questions just ask away (after searching of course). Guys here are so helpful...

And you have a treasure trove of parts available over there.

Btw, welcome

 

[CLuTZ]

Sup cuzzie- where you from?? Had to find a mint GSR or VR4 over there these days! All been hacked to death!!

 

[Kanos]

Cheers everyone! I'm up in Whangarei haha. Yeah this CD5A isn't in the best condition...has had a bit of a ding in the back quarter panel but is just rippled. Engine was a bit of a mess, oil leaking from rocker cover and crank seal. One of the leads was hanging off for who-knows how long. Knock sensor disconnected. Cambelt was half shredded and water pump slightly leaking. Since then it's had new leads, plugs, cambelt, water pump, tensioners and idlers, rocker cover gasket, coolant, etc etc. Still running slow, so fitted an evo2 front mount and made it a little better...bought some mods recently so hopefully I'm going down the right path haha just time to fit them and how!