Rear Spoilers For Sale - non-mitsubishi

[PSIfer]

Located in Brisbane, QLD, I have two rear spoilers for sale (or permanent Hire ):

The first is a narrow, 2-post fibreglass rear spoiler with centre brake light. Model of car it was originally for is unkown. Will match any colour of car you have, so long as you respray it that colour first. Has been undercoated and rubbed smooth & does require painting.
Dimensions are approx as follows:

Over-all Width = 117.5cm
Post-to-Post Width = 103.3cm
Height = 10.0cm

Best Offer above $40 will take it home. Postage, if required, will be on top of that. No handling charge what-so-ever .

The second rear spoiler is a full metal (rare being metal) 4-post spoiler from an Audi 90. Makes for a nice alternative on a VR4 (as can be seen from the photos below - note: not actually fitted , just sited for the photo, & yes my car is very dirty ), or for any car with a suitable bootlid. It's moroon (deep red) in colour and would require redrilling of the bootlid if wanting to fit to a VR4 (holes don't line-up perfectly).
Dimensions are approx as follows:

Over-all Width (tip-to-tip) = 133.5cm
Outer post-to-post (bolt holes) = 120.5cm
Inner post-to-post (bolt holes) = 57.2cm
Height = 7.5cm

Best Offer above $50 will take it home. Postage, if required, will be on top of that. No handling charge what-so-ever .

These are BELOW the prices I paid for these spoilers.

Am open to trade, barter, swap for the guys in Brisbane.

If you absolutely must call me about these spoilers you can reach me on 0412279091 .

Judd.........

 

[MDK87]

LOL! hahaha
Judd your posts are always full of a bunch of laughs!
Nice sig btw.

Heeeyyy, isn't that second spoiler the one that you used to double up? It looks good in that pic. It looks like it fits the bootlid quite well too.

 

[JAP63]

Fits like a bloody stock item that second on,,Jayrome! do you see this?

 

[PSIfer]

Heeeyyy, isn't that second spoiler the one that you used to double up? It looks good in that pic. It looks like it fits the bootlid quite well too.

The one I was intending on using as a double-up (or double-decker) rear spoiler is the top one in this post Mo. It fits on top of a standard VR4 rear spoiler, would just need to be attached, wiring routed thru lower, standard spoiler, and attaching points blended in (i.e. a bit of custom work required). Then you'd have a doubled rear spoiler with 2 brake lights - one on each spoiler.

The second spoiler I've posted here (the lower picture of the two) is off an Audi 90, and as Jap63 has righfully pointed out, is a bloody close fit to the standard VR4 rear spoiler.

..........