Rear Trailing Arm between EVO 1 and 2/3

[jonbatz01]

Hi Guys,

i can seem to find an answer for this.

Firstly, i found that my rear left Trailing arm is slightly dented, bearing has now gone on it as well so i am looking to replacing the whole piece with new bearings a bushes.

So far i have been offered an E1 rear trailing arm but i cant seem to find any info on whether the E1 is same as the E2/E3. I am only cautious because i understand the the E1 front control arm is different from that of the E2 and E3 so a little weary.


Thanks for the help guys!

 

[BMGTZ]

same..same in terms of fitting

gsr is a little different to look at...but again fits up same

 

[jonbatz01]

so it will be ok to run an E1 Trailing on the Rear Left and my normal E2 one on the Rear Right?

its of no different at all Brian?

same..same in terms of fitting

gsr is a little different to look at...but again fits up same

 

[BMGTZ]

just make sure the one you get has abs tone ring if yours has abs.

I probably have gsr and evo here if you want to see the difference. If there is a diffence between the evo arms it wont be much

 

[EVOCPE]

Ive come across a few different arms, its confusing

Below is a pic of GSR vs EVO

Now as you can see the EVO has a bigger outer bush, but ive seen with a smaller outer bush but still have the bottom plate and Rob has GSR rear arms with bigger outer bush

Anyways

Also CD5A part# = MB809232, CD9A = MR197605, CE9A = MR197609 (same as DE3A FTO)

 

[GeoKez]

I think he was referring to trailing arms EVL. But your post helped me, thanks

 

[EVOCPE]

Oh crap, I read it wrong lol

Glad to have helped

 

[jonbatz01]

Thanks Guys for the comments.

Will probably just stick to getting an E3 one just to keep everything the same as before