{{{{ SOLD }}}} Mitsubishi Galant VR4
- Thread starter Gorba
- Start date
Help Support 4GTuner:
- Status
JayRome
Blurring the line between 1st to 3rd Gen engines..
aust spec with what looks like Jsped intercooler (offset in, middle out) with custom mild steel pipes
has 2.5" exhaust with what looks like custom split dump,
looks like a TD05 (couldnt tell if it was the big or small)
has 055 maf (possibly eprom'd ECU and needs a hell of a tune)
engine has many oil leaks alot of it coming from the rocker cover
Strut brace already sold to me lol
car has front left hand damage
rear left quarter and bumber damage
missing right hand rear side skirt under the rear door which goes half way up the wheel arch
does not come with the boost gauge as pictured
car idle's pritty well although its set to almost 1800rpm+ when cold (could be tuning)
didnt see any black smoke or blue smoke when started
usuall lifter noise but sounds like the oil hasnt been changed in a while
paint needs a good re do
lowered bout inch or 2
batt moved to boot.......
thats all i could figure out in the whole 5 mins i looked at it.... nice guys to talk to (name: Carlos) would go well as a project car or a wreck... its either going to a good home or a wrecking yard.....
has 2.5" exhaust with what looks like custom split dump,
looks like a TD05 (couldnt tell if it was the big or small)
has 055 maf (possibly eprom'd ECU and needs a hell of a tune)
engine has many oil leaks alot of it coming from the rocker cover
Strut brace already sold to me lol
car has front left hand damage
rear left quarter and bumber damage
missing right hand rear side skirt under the rear door which goes half way up the wheel arch
does not come with the boost gauge as pictured
car idle's pritty well although its set to almost 1800rpm+ when cold (could be tuning)
didnt see any black smoke or blue smoke when started
usuall lifter noise but sounds like the oil hasnt been changed in a while
paint needs a good re do
lowered bout inch or 2
batt moved to boot.......
thats all i could figure out in the whole 5 mins i looked at it.... nice guys to talk to (name: Carlos) would go well as a project car or a wreck... its either going to a good home or a wrecking yard.....
iluszn
Well-Known Member
Had a quick look a couple of hours ago.. and deposit has been taken.
Needs alot of TLC but i think with a few months of work the car should come up ok.
Drivers guard big den
Passenger side guard needs replace
Passenger indicator require
Passenger rear guard pushed in
tail lights not working.
car idles rough and lumpy.
cooler piping is mild steel and will need redoing due to the quality (And positioning)
interior is not to bad
has the usual power steering/Cruise/PM/PW/Manual
Clutch is DEAD!!!!
oil leaks round rocker, did not see any drips
Oil is not cloudy so headgasket is ok.
lowered
needs all 4 tires maybe brake pads aswell (2B inspected)
Will do nicely as my daily once its on the road.
cheers
Needs alot of TLC but i think with a few months of work the car should come up ok.
Drivers guard big den
Passenger side guard needs replace
Passenger indicator require
Passenger rear guard pushed in
tail lights not working.
car idles rough and lumpy.
cooler piping is mild steel and will need redoing due to the quality (And positioning)
interior is not to bad
has the usual power steering/Cruise/PM/PW/Manual
Clutch is DEAD!!!!
oil leaks round rocker, did not see any drips
Oil is not cloudy so headgasket is ok.
lowered
needs all 4 tires maybe brake pads aswell (2B inspected)
Will do nicely as my daily once its on the road.
cheers
- Status
