Zacariah Ashby
Active Member
Hey guys taken my jap spec cable out to put in aus spec,anybody know how to take out from the box? already taken out the 10mm bolt/nut but still carnt get it out, any help?
Cheerz
Cheerz
Speedo cable
- Thread starter Zacariah Ashby
- Start date
Help Support 4GTuner:
Ross Cox
Well-Known Member
It should pull straight up, you may need to spray around it with RP7 or the like. It has an o ring .Also you may need to get a screwdriver under the flange between the bolt hole and the drive.
Be careful not to break the bolt flange
Cheers
Ross
Be careful not to break the bolt flange
Cheers
Ross
Zacariah Ashby
Active Member
what do u mean by drive?i still carnt get it to pop out from the gbox
Ross Cox
Well-Known Member
https://www.flickr.com/photos/12865148@N04/12850141503/in/photostream/
This is the 'drive' for the speedo. Under it is a plastic bevel gear that engages a gear on the diff. Undo the bolt, leave the cable in the 'drive' and pull it straight along the line of the cable. It has an 'o' ring and may be difficult to lift. You can place a screwdriver under the edge of the 'drive' and lever it up. Careful not to break the tongue off. 'Tongue' being the part that the bolt goes through. Cheers
Thirsty
This is the 'drive' for the speedo. Under it is a plastic bevel gear that engages a gear on the diff. Undo the bolt, leave the cable in the 'drive' and pull it straight along the line of the cable. It has an 'o' ring and may be difficult to lift. You can place a screwdriver under the edge of the 'drive' and lever it up. Careful not to break the tongue off. 'Tongue' being the part that the bolt goes through. Cheers
Thirsty
