Turbo banjo thread size

[VIN18M]

Hey guys, I need to get a 180 degree hose end to run off the banjo bolt on my turbo as my current one causes the water outlet line to kink. I'm looking at something like this...

http://www.ebay.com.au/itm/10AN-AN10-AN-180-Degree-Push-On-Line-Hose-End-Lock-Fitting-Adapter-x-2-pcs-/261446193076?pt=AU_Car_Parts_Accessories&hash=item3cdf684fb4&_uhb=1

I can't get the fitting off the car without pulling a heap of it apart to get to it and won't be able to do this till the weekend, but I'll be nearby to a Pirtek outlet tomorrow and wanted to pop in and grab one.

Anyone have any idea what size I should be getting?

 

[VIN18M]

I'm looking to replace this 90 degree fitting with a 180 so I can run the hose directly down...

 

[DOUGMO]

if you need a 180 wouldn't it be better to spin the banjo so it points down?

but to answer you question it depends what thread/fitting design you have as its not a stock setup

 

[VIN18M]

I tried that when the engine was out, the problem is that the banjo hits the bolt in the turbo below it and you can't screw the bolt in all the way. I know some people have used extra washers but they are always prone to leaking that way.

I've just found the answer on the kinugawa website, they have the individual banjos available to purchase on their own and all of the specs for each.

http://shopping.kinugawaturbo.com/banjoboltkitm14x15mmto-4angarrettgt28rgt30rgt35rt28turbocoolant-1.aspx