WTB: QLD ONLY: Stock VR4 Flywheel

[WRCVR4]

Im in need of a stock VR4 flywheel, which is located in Brisbane.

I need to give Jim Berry one, so he can set it up for my new clutch.

MUST be serviceable.

 

[rob323]

Sorry, I gave my last good one to Ben :evil: which he gave to Jim Berry when he got his clutch made, by the way, you will need an A spec or facelift flywheel. The early J spec flywheels won't take Jim's pressure plate.

And make sure he balances it (he doesn't normally do that).

 

[DOUGMO]

he did not need a flywheel to build mine up?

what does he need to do?

 

[rob323]

When Ben got his done, Jim machined the flywheel to suit and filled the ventilation holes with metal putty (as he reckons they can crack from those areas).

 

[DOUGMO]

there is no trick to how they are setup, he sets them up for standard height.

the putty is only to stop a vacuum drawing oil from the rear main.
no 100% necessary imo.

 

[rob323]

he sets them up for standard height.

Yep, I check measured Ben's before we installed it. It was just the standard step height.

the putty is only to stop a vacuum drawing oil from the rear main.

I would have thought that the breathers in the bell housing and the inspection plate which isn't sealed to anything would be more than adequate to stop that being a problem.

 

[DOUGMO]

that is the reason jim gave me when supplying the clutch for my car,

i am running a different flywheel anyway on my car

 

[yelevo]

flywheel

I have one let me know if you still need it.

 

[DOUGMO]

the putty is only to stop a vacuum drawing oil from the rear main.

I would have thought that the breathers in the bell housing and the inspection plate which isn't sealed to anything would be more than adequate to stop that being a problem.[/quote]

me too

 

[WRCVR4]

Thanks guys, but i have acquired one of those light fandangled ones :roll:

 

[DOUGMO]

what did you end up getting mate?