XForce Exhaust

[Jonson]

Anyone with a CT9A run an XForce Turbo back or cat back exhaust? How did you find fitment and quality?
Price is reasonable, Stainless, made in China.....

Thanks,
Jon

 

[DOUGMO]

they are ok mate, not spectacular- fit prety well and quality is up to par but not magnificent

 

[adamgsr]

They ok, used to have one on my gsr and it was fine and sounded good too

 

[Jonson]

$1700 for full TBE with muffler and Cat. Dump, front and mid sections are only 2.5"
D&T will do me a full stainless hand made job with Metal Cat cat and my choice muffler for $1700, but need the car for 2 days.

The age old question - Bolt on vs. custom.
Thoughts?

 

[DOUGMO]

if its 2.5 or 3" then custom all the way

 

[Liberoz]

3"inch all the way also, way go backwards just cause its a bolt on DIY for the same price go custom 3"

 

[Jonson]

just considering options. I have found other bolts on that are 3"
Tomei expreme seem to be ok, ok priced for dump and front pipe. just need to get a cat after that.

 

[Liberoz]

just considering options. I have found other bolts on that are 3"
Tomei expreme seem to be ok, ok priced for dump and front pipe. just need to get a cat after that.

Don't quote me but 98% sure Tomei frt pipe's aren't 3"

 

[Benny]

They aren't, mine was 60mm from memory, it promotes more torque though.
I'd go Tomei dump, front, 3inch highflow cat and if you're on stock turbo, then 3inch rear end isn't a must, you'll get a better street car with the slightly smaller piping.

 

[camo]

they made the cat i got off them wrong and took a lot off rootin around and cutting to get it to fit, btw if your changing the dump off your turbo youself good luck, its a farking mission

 

[Liberoz]

they made the cat i got off them wrong and took a lot off rootin around and cutting to get it to fit, btw if your changing the dump off your turbo youself good luck, its a farking mission

not as much of a mission with the right tools, but be careful of snapping studs