5 replies to this topic

[lchilds82]

Started Build today by removing the 4g63t vr4 engine out of the doner car:thumbsup: lots of fun that was.

Befor the engine goes into the GB Galant needs abit of a refreshener, new gasket and seals, new timing belt kit and new cams should make her frrl a bit nicer.

I have the starion mounts to start the mocking up will let yous now how i go
Here some other work i have done so far to the car, slow process for me(work to much)

Bit of rust in the wheel arches so i removed it all and learnt how to weld]

Little bog over to smooth and not bad for a noob

Edited by lchilds82, 26 April 2010 - 12:08 PM.

[murray]

we all have to start somewhere. good luck

[lchilds82]

thank you i think ill be needing it

[ozyvr4]

Sweet stuff champ. What diff are you going to use?

What are you going to do about the crazy diff tramp that galants have. I had a set of slapper bars made for mine. They were fantastic.

A couple pics of my galant. It was a GA with the GB front lights & grill.

Attached Thumbnails

• 
• 
• 
• 

Edited by ozyvr4, 26 April 2010 - 12:45 PM.

[lchilds82]

dude that is the best car ive seen for ages loving it

[Chaser]

love the 20v ozy