24 replies to this topic

[Smutt]

Turbo - $700 Garrett GT 3076 - 525 hp - essentially see below
Garrett Gt3071 with 3076 wheels with 0.63 A/R
on my 1.8 held 30psi all the way to 8800
This compressor map pushes up to 36psi (still in efficiency plot on graph)

Evo 2 mechanical LSD rear diff - $500

Pwr water pump and fan and 10" radiator for Water to air system $300

Custom dump pipe (suits no aircon and remote oil filter) & 3" mandrel bent exhaust $350


Almost Brand new excedy brass button clutch purchased from NPC Brisbane (clutch literally only done 10kms) - $300

Bosch External 700hp fuel pump and surge tank - $150

Eboost1 - $300

ECU with Programmable chip just like ECM lite - Using Ostrich Emulator, Tunerpro RT and Pocket Logger to log under load. - $400










YOUTUBE Link - not my PB but close

http://youtu.be/rvJOurjlCTs?t=7s

Attached Thumbnails

• 
• 
• 
• 
• 
• 

Edited by Smutt, 01 February 2014 - 10:10 AM.

[evo-gsr]

Is the pro comp boost guage spoken for or available? 

If available Im keen as.

[Smutt]

Still available. 90 it's yours

[hendo]

may be keen on chipped ecu depending on price. Is it a gsr ecu or evo?

[Smutt]

GSR ECU
!EDIT!
This ECU is not just chipped its programable via ostrich
More info to come

Edited by Smutt, 19 December 2013 - 09:07 AM.

[evo-gsr]

Still available. 90 it's yours

Pics please Sam? Definitely keen.

[Smutt]

Pic

Attached Thumbnails

• 

[evo-gsr]

One more question? What size is it please?

[Smutt]

The big one 2 & 5/8"

[evo-gsr]

Done deal. Please pm me payment details?

[VIN18M]

Might be a stupid question but is the turbo suited to the standard 4g93t turbo manifold? I'm assuming its a T2 flange?

[Smutt]

Standard exhaust manifold that has had the restricter ring removed and then a custom made adaptor plate 30mm thick that is round to rectangle and ported to the Garrett inlet, upload pic tomorrow

[Smutt]

Might be a stupid question but is the turbo suited to the standard 4g93t turbo manifold? I'm assuming its a T2 flange?

 

As stated above, running a custom adapter plate round to rectangle. This works well, the numbers speak for themselves.

 

The plug in the front of the plate was put there to measure pressure in the exhaust manifold in comparison to boost levels in the intake manifold (difference was only +2psi).

Attached Thumbnails

• 
• 

Edited by Smutt, 20 December 2013 - 04:19 AM.

[Smutt]

ECU details edited in original post

[matts4g]

Are you selling your momo wheel?

[ENGINR]

If you have an (undamaged) EVO bonnet I'll be keen on that!

[Smutt]

Momo wheel not for sale, don't have Evo bonnet

[Smutt]

Gearbox Sold...

Edited by Smutt, 23 January 2014 - 06:36 AM.

[Smutt]

If your super keen, message me, you never know

[Smutt]

Prices!

And edit