7 replies to this topic

[moonchook]

got a few bits left over from wrecking my RVR

 

1. Transfer case, for WM533 manual box

 

came from an RVR hyper sports gear

 

 

$150ono

 

2. Tailshaft from RVR HSGR

 

$$offers

 

3. crossmember from RVR HSGR

 

$$offers

 

4. Headlights 2 sets, black surrounds and normal

 

$$offers

 

 

5. waterpump and timing tensioner/idlers

 

$$offers

 

 

more as I dig it up

 

all parts are located northside brisbane in the caboolture area.

 

Edited by moonchook, 20 September 2014 - 03:56 AM.

[Hyper_Mike]

Hey man, are these all the bearings needed for when I do the timing belt swap?

 

Cheers, Mike

[moonchook]

Hey man, are these all the bearings needed for when I do the timing belt swap?

 

Cheers, Mike

should be I bought it as part of a timing belt kit, the water pump is GMB by the way, the bearings are "Kabuki" branded, the bearings themselves have NSK and NTN markings so are likely manufactured in japan.

 

edit: not 100% sure if the pump is GMB, its in a GMB box but honestly the quality of the casting looks a little worse than other GMB pumps I have seen.

 

$40 posted the lot (to the gold coast) if your keen

Edited by moonchook, 20 September 2014 - 04:19 AM.

[LumpyVR4]

What sort of condition is the transfer case in? Also could you please confirm the spline count and the ratio? I'm not sure if it would match VR4 (1.090), or EVO 3 (1.074).

 

Thanks

[moonchook]

What sort of condition is the transfer case in? Also could you please confirm the spline count and the ratio? I'm not sure if it would match VR4 (1.090), or EVO 3 (1.074).

 

Thanks

 

how do i get the ratio? counted 23 splines

[LumpyVR4]

http://www.galantvr4...&page=3&fpart=1
 

About 2/3rds of the way down the page.

[BYBY5L]

Water pump, tensioners etc, how much are ya after, shoot me a pm with all the details and a phone number,

[moonchook]

http://www.galantvr4...&page=3&fpart=1
 

About 2/3rds of the way down the page.

 

will check it out for you tomorrow, still have the tailshaft here.

Edited by moonchook, 21 November 2014 - 11:31 AM.