How much? Just out of curiosity...
Welcome to 4GTuner
Register now to gain access to all of our features. Once registered and logged in, you will be able to create topics, post replies to existing threads, give reputation to your fellow members, get your own private messenger, post status updates, manage your profile and so much more. If you already have an account, login here - otherwise create an account for free today!
Register now to gain access to all of our features. Once registered and logged in, you will be able to create topics, post replies to existing threads, give reputation to your fellow members, get your own private messenger, post status updates, manage your profile and so much more. If you already have an account, login here - otherwise create an account for free today!
#21
Posted 23 November 2014 - 04:13 AM
TBOWGN
-
- Active Members
-
- 693 posts
Advanced Member
- LocationGold Coast
Back to top
#22
Posted 23 November 2014 - 06:20 AM
xjokux
-
- Active Members
-
- 772 posts
Advanced Member
- LocationBrisbane
Mine?I'll have a for sale post this week.
- TBOWGN and Hyper_Mike like this
1991 CB Lancer GSR. Fully restored. Forged vr4 motor. FP Manifold. 20g. 38mm Tial wastegate. 3" Punishment Racing dumpipe. FIC 950cc. Ecmlink. Koni inserts coilovers. Evo 4 brake setup. Sprint 15' Harts racing. 280 cams. 4g61 inlet. Evo 8 Throttle body.
1995 SSG RVR
2014 ASX Diesel 4WD
#23
Posted 25 November 2014 - 01:29 PM
penngwyne
-
- Active Members
-
- 356 posts
Advanced Member
- LocationNaracoorte SA
Even if the car is really clean slide under the front LHS and check for any oil or fluid around the bottom of the timing cover.
Could indicate shaft seals need doing or water pump leaking
Need new timing belts if it got oil or fluid on it
Also see if coolant (not water) is clean and up to the mark and see if all coolant hoses feel OK especially the smaller ones around the throttle body and to the heater.
(Crunchy hoses is also not good) If the overflow tank is full of gunk it probably will need a flush.
While looking under the lid also check the tops of the front struts for cracks in the rubber of the joint.
None of these jobs are impossible as DIY but some care is needed and a lot of reading to find stuff.
If you do get one I recommend the Mitsubishi ASA to download from the forums here for part numbers and drawings (I can't quite remember where it is )
Still love the RVR but am paranoid about little noises
#24
Posted 30 December 2014 - 09:05 AM
CPDST
-
- Members
-
- 15 posts
Member
- LocationDunedin, New Zealand
Thanks for all the tips!
So as it happened my regular car (the EP91 Starlet) decided to have clutch problems.
And so then as it happened I didn't really want to invest in a new clutch for a car I didn't enjoy in the first place.
Whilst I would have replaced this with an RVR, it isn't really a car I can afford to run, in terms of fuel consumption - having had experience with an RVR before, I know this to be true.
So I went out and purchased a Toyota Caldina. :-D (1998 1.8E) Which cost less still than any RVR I could be looking at, and is better equipped and fits my needs better. So I just wanted something reliable, wagon shaped.
I'm sorry to disappoint! Maybe when I graduate from university and in theory have lots of cash, this will happen.
Once again thanks for all the tips.
Craig.
3 user(s) are reading this topic
0 members, 3 guests, 0 anonymous users
