moonchook

http://www.galantvr4...&page=3&fpart=1
 

About 2/3rds of the way down the page.

will check it out for you tomorrow, still have the tailshaft here.

What sort of condition is the transfer case in? Also could you please confirm the spline count and the ratio? I'm not sure if it would match VR4 (1.090), or EVO 3 (1.074).

 

Thanks

how do i get the ratio? counted 23 splines

Hey man, are these all the bearings needed for when I do the timing belt swap?

 

Cheers, Mike

should be I bought it as part of a timing belt kit, the water pump is GMB by the way, the bearings are "Kabuki" branded, the bearings themselves have NSK and NTN markings so are likely manufactured in japan.

edit: not 100% sure if the pump is GMB, its in a GMB box but honestly the quality of the casting looks a little worse than other GMB pumps I have seen.

$40 posted the lot (to the gold coast) if your keen

got rid of this a couple months back, have a few bits and pieces lying around but will start a new thread, thanks guys.

hit me up if you want a used one, though new would probably be better peace of mind cos its not something you want to replace more than once!