ChrisVR4

Hey lads,

I'm wanting to upgrade my cams and injectors, so i'm checking if anyone is interested in my currently installed gear.
This stuff has served me well.


INJECTORS
The injectors have been sweet, they are still in perfect condition, and i should still have the flow test sheet for them.
             Asking $200 including post in aus    


CAMS
The cams are in fantastic condition too. I have had one cam licked over on the grinder due to some pitting, so one is like new, and the other is as good as you can get second hand.
I have had these cams dropped in with the stock valve train spinning to 8000rpm, and not a hint of trouble.

Hopefully the SD tables go up okay. I think they are quite cool to look at, and see the real-world gains.
The 272s come on song at 4500rpm, and have a 25% flow increase at 7000rpm

My stock cam SD table 
 sdstock.jpg   95.85KB   88 downloads

272 SD table
 sd272.jpg   97.47KB   98 downloads

          Asking $320 including postage in aus



You can message me here or text me on 0447044062.
Mobile preferred



Cheers Chris, 

Hey guys,

I've got two manifolds here that are taking up shelf space.
Both in Horsham VIC. I travel to Melbourne regularly, so I can do a meet up if needed.

One is an Evo 3 stock manifold. 
Good upgrade from a stock gvr4 manifold, because they are a little bigger on the outlet to the turbo, but mainly because they dont seem to crack in the webbing like the stock vr4 manifolds.
This one has had an EGT sensor, so there is a bolt plugging the hole in one of the runners. Also has a couple of bolts broken off in the heat shield mounts.
Price $70



The other one is a used GT Pumps aftermarket manifold.
Very beefy compared to the evo and vr4 manifolds. 
I believe that it is probably the best manifold to use if you want to keep your engine bay looking standard.
it has heaps bigger runners and turbo outlet, but is a bolt on replacement.
Price $150


I am neIgotiable on price.
If anyone shows interest, I will get some pictures up ASAP.
My contact number is 0447 0440 62

Chris


 

Hey guys,
I've got a maf from a 6litre ve, 5pin, internal iat sensor, and a splitter cable that will let you plug into ecmlinks gm maf adaptor.
Not sure if you would call it 3.75 or 4 inch.
Its 4inch on one end, 3.75 on the other.

Its in perfect condition.
I was going to use it with a 4 inch intake, but I've had to step down to 3" because cramped up vr4 bay. So I'm using a 3" maf.

Located in Horsham, Vic.
Will post.
Looking for $200

Contact number is 0447 0440 62

Cheers,
Chris