Search results

thought you wanted a set of mine Dan?

thought you wanted a set of mine Dan?

the state of tune and initial setup. One setting should be 60 degrees, was set to 74

yes mate... thankyou for your help. Turns out there were a few problems with my map too....now gotta change a fair bit. but all running now...

I never insinuated anyone was trying to rip anyone off and I certainly never said you were trying to trick people into buying something they don't need. I was just informe by the SA Wolf dealer that mine was setup for sequential injection. Perhaps I was misled, not sure. You may apologise any...

any luck Baz? this is kinda gettin urgent.... need me car running

I have to rewire my cam angle sensor, due to a bad wiring job. Can anyone tell me what resistors to use and exactly where they are wired in? Thanks in advance.

yes I know, 2nd hand is what I am after.... or I woulda been in touch weeks ago :D

and unless you give me one, it seems pointless to post on my wanted thread.

bump

then I need a 16g ex housing. used, minimal cracking. sooner rather than later if possible...

still looking.....

I need a small 16g ex housing. please PM me prices and postage to adelaide. Cheers

funny, mine seems to run sequential injection without modified disk.....

hey guys, anyone in adelaide got an engine crane and valve spring compressor I can borrow asap? Happy to part with a few pennies or alcohol :D cheers David PM or sms 0429 015 085

would the E6 ones fit ok? Jon, Dan, thanks... will be in touch.

sounds like my VR4 motor just let go of a piston. Therefore my toy needs replacements. Anyone got good cond used? (heaven forbid). Or can anyone get me a good deal on new ones? On a real tight budget, so any help is appreciated.

GTO calipers run on minimum 297mm rotors. Can make brackets using 24mm 6061 aluminium yourself.... I run 17" wheels, but pretty sure 16"s would be ok.

define cheap....

how about stainless steel ones with acrylic faces?