Wolf 3D help.

[grumbly]

I have to rewire my cam angle sensor, due to a bad wiring job. Can anyone tell me what resistors to use and exactly where they are wired in?

Thanks in advance.

 

[bazeng]

basically u have to supply a 12v signal to the triggers

use 1k ohm resistors x2

you have to wire it in parallel from the +12v to the 2 triggers...(ref and sync)

From memory, they 2 triggers are the black and brown?...
black is earth and red is 12v...

not positive, but ill confirm tommorrow
i have it written down..

 

[grumbly]

any luck Baz? this is kinda gettin urgent.... need me car running

 

[bazeng]

okay
here ya go mate..
from my personal notes

btw, if possible, post up your map!
i'd like to see how you setup your ignition / injection

 

[bazeng]

oh yeah, try and wire the CAS to 12v+
you can do this at the start of the loom..
you will get a better signal
set the signal strength to medium also...

 

[bazeng]

get it working yet?

 

[grumbly]

yes mate... thankyou for your help. Turns out there were a few problems with my map too....now gotta change a fair bit. but all running now...

 

[bazeng]

what type of problems?

trigger settings or just state of tune?

 

[grumbly]

the state of tune and initial setup. One setting should be 60 degrees, was set to 74

 

[bazeng]

ah okay
so its up and running now?