Search results

I know of a few people using Blox and Torque solution mounts in CP so its confirmed they fit however they make the engine sit about 5mm higher due to the CT bracket offsetting the hole location 5mm higher.

"Gools VI" or hairy lemon runs 265+ tires on his evo 6. He has a build thread on various forums worth chasing but the guard work isnt simple... anything will work if youre ride height isnt too low lol... Currently running 235/45/17 on 17x9+22, fronts fine and like others said the rears...

^ I have one-piece and advise against trimming. De-rivet the 3 pop-rivets so you can revert if possible in future. I use normal incandescent bulbs in the projector style headlights and it is still an improvement over OEM but HID is better. Water sprays you can DIY adapt any...

These fit evo 6 head? sorry im a newb at valve-train stuff? Im in Sydney area so need postage.

Paint stripper is not good on the dust seals as they are rubber. If you rebuild them its fine. Decals I've used Meeks and ebay spec. Both work fine under heat even after track day. Clear coat, at least 3M 650 degree high heat from a rattle can, caused brownbo effect on my calipers after a...

Someone replied to me and measured the BLOX front roll stopper. 35mm wide 130mm long 85mm height (approx) 95mm between base bolt holes If the base is 95mm then im convinced it will work, not sure on the position of the center hole of the bush but it should work.

Well it appears the arms are symmetrical despite the different part numbers listed for the OEM bushes. Interestingly, the whiteline and similar aftermarket bushes are the same for Left and Right which implies symmetry. I took it off the car and they are geomtrically the same except for the...

Im keen on the "evo 6.5 Tarmac option wheels there wider )... 17x8.5" Would like to know offset, if it comes with tires(its condition), total cost inc shipping to 2220 Sydney and finally how soon you can send them out. If there are any damage to the wheel, a photo would be great of each wheel...

I see the parts catalogue have different part numbers for OEM bush for L and R but the aftermarket ones are dont distinguish. After a good clean, the lower arm I have has a pink dot on one side and opposite side has "G N" stamped on it. Basically im trying to find out if I can use this Evo 8...

Thanks DOUGMO for quick response! If anyone knows if that part can be flipped 180 degrees to be used on either side please confirm. Thanks in advance, derku

Hello again, I attached an image of a lower control arm from an Evo 8 MR. Will they fit CP9A? and are they symmetrical? Thanks in advance. derku

Yep I saw those bushes =] I then looked into 'bolt-off bolt-on' products as I dont have a press or a means to get the OEM bush out PROPERLY. The simplicity of the after market CT ones just seemed appealing so thats why I posted this up to ask if CP and CT are compatable. I've done all I...

Thanks for all the info. I've finally removed the front engine mount to see for myself; did some basic measurements. Wonder if anyone with CT9A stock front roll stopper mount or after market ones could compare for us? Measurements in this image: hope it works.

I forgot to add, if anyone would direct me to specific product/vendor in Sydney, that would be great!

G'day, I have an Evo 6 and I tried to increase 'stiffness' of the engine and invested in a torque damper but was dissapointed with the result. So now im seeking to replace front roll stopper now with an stiffer one. BLOX and Torque ones interest me but I can only find them to suit Evo 7-9...