6 Bolt Engine and VR4 Shell

4GTuner

Help Support 4GTuner:

dakiller

Well-Known Member
Joined
Aug 31, 2011
Messages
64
Location
Melbourne
VR4 6bolt motor
complete longblock
(compression numbers take just before the motor was taken out 138, 140, 135, 142)
intake manifold, no TB
stock injectors, rail and regulator
stock 14b turbo and manifold, dump, o2 (chopped plug)
3" cat back exhaust (cat is empty though) and cannon if you want
stock clutch and flywheel, clutch lines & slave cylinder.
box of intake pipes and MAF

New Timing belt, pullys and water pump done. < 10,000km on them.

I got the car with a broken timing belt and bent valves, car was on 270,000km previous owner had engine replaced at about 200,000km from paperwork I got. Replaced head with another stock and have put 100,000km on the car in 4 years, oil change always done by 7,500km using full synth. Plenty of problems with the car in that time, but none with the engine.

Reason it was pulled is that I built a new motor that'll do bigger skids :)

No wiring loom
No Alt, AC or Powerstearing gear
No starter motor
full set of dead engine mounts, all need rubber replaced

Problems -
Small oil leak around front main seal area, just makes a mess over time really
Timing cover has seen better days, crank pulley failed and rubbed a bit of a hole it in.
broke exhaust stud, got helicoiled, holds well now
1 broke thread on spark plug plate on valve cover

Pictures -
http://imgur.com/uihOzaQ
http://imgur.com/dsJC7IE
http://imgur.com/EKiOAmF

Looking for $1300




VR4 Silver Shell
All staight panels.
Missing glass in all but rear drivers door and windscreen.
Failing paint.
Stripped interior - only dash and rear seats left.
No engine or drive line, except rear diff and axles.
Stock rims with passable tread tyres. (black rims in picture are spoken for)

Picture -
http://imgur.com/Cm8qLal

$150 / Free if you buy something else I got.


Other things I have lying around.

Stock VR4 Intake Manifold

14b Turbo, manifold and dump

Make some offers

All available for pick up in Warragul, 1 hour east of Melbourne.
 
hurm.. could you be bothered ripping out the rear diff and axles ?
 
You wouldn't have the Jap-spec rear bumper? Is that it on the ground?
Would you send it to Brissy...Pretty please?
I've been desperately looking for one..
Thanks.
 
JayRome said:
hurm.. could you be bothered ripping out the rear diff and axles ?
I want the whole thing gone

MDK87 said:
You wouldn't have the Jap-spec rear bumper? Is that it on the ground?
Would you send it to Brissy...Pretty please?
I've been desperately looking for one..
Thanks.
They're A spec bumpers, the front is on the ground there and the rear still on the shell
 

Latest posts

Back
Top