Best entertainment/performance ideas for rvr dash

[Benzo4gT]

↑ Nice! Not very common at all, only other person I know who has one is Rockabilly.

 

[TBOWGN]

Wow, just a compartment under there?

 

[4th]

Wow, just a compartment under there?

yes, but if you wanted a static display not a pop-up that appeared factory look for a pajero around the same vintage like this attachment

 

[Django]

Hey 4th my old one had the same compartment, also had woodgrain trim going around the inside top of the dash (same level as the clock) all the way round. I just assumed those compartments were standard on all rvr's. Heaps of them had different co-ordinations for the where the woodgrain trim went too from what I've seen here and other places. Very kewl

 

[TBOWGN]

Well after all that fuss I bought a second hand double din kenwood for $100 to fit in the usual spot

Thanks anyway guys, hopefully it'll help someone

 

[MrConsistent]

This i what I have done in mine a 7" touch screen in standard spot is not only pretty useless but also a bit dangerous so custom housing and in easy sight and reach :thumbsup:

 

[Rockabilly]

^ Mad electric wiring ;-) 300kph speedo & other look cool.
Cheers

 

[TBOWGN]

My God!!!! Tell us more about your speedo set up? And do you have a build thread?

 

[MrConsistent]

My God!!!! Tell us more about your speedo set up? And do you have a build thread?

A bit too busy/lazy for a build thread my RVR is scattered all over different pages....
The speedo, Tacho and quad gauges came from Speedhut over in the states Love them the speedo works on a electrical pulse i used a sender from a Mitsi GTO (screws straight in Just make sure you get the little shaft also )
Tap in the wires for turn signals and high beam, the speedo pulses are just programmed in so it is very accurate .5 of a KM according to my gps
The tacho easy as to hook up and the quad Fuel/Batt/Temp/Oil pressure comes with all senders and the fuel is programmable :thumbsup:
The whole thing sits in an old gauge cluster that i just cut out so the stock mounting bits are all there just cut out a new face for the gauges.

 

[TBOWGN]

Nice!!

Engine specs?

 

[MrConsistent]

Nice!!

Engine specs?

Nitto 2.3 ltr forged stroker,
I beam CNC rods,
272 HKS cams,
buddy club ADJ gears,
BC springs and Ti retainers,
magnus intake 78mm TB,
custom exhaust manifold Borgwarner 7670 twin scroll turbo,
2000ID injectors,
Haltech PS1000,
Autronic 500R CDI,
M&W COP system,
3.5" exhaust magnaflow muffler,
ALDO special 4spd Auto, front Quaife,
Rear Mech LSD.
So yeah pretty stock so far h34r:

 

[TBOWGN]

Mental! Put it down the quarter? Or on the dyno?

 

[MrConsistent]

Nope not yet. hoping to solve the last little problem and then off to tune hopefully all in time for Temora 1000.