So I've just had my tailshaft rebuilt, went to put it in and the carrier hanger didn't fit - like the holes were too far apart. After taking it back and having a look between the two and trying to take some dimensions from the car, it seems like that is exactly what's wrong. The (rough) measurements I got from the car have the bolt hole centres at 175mm. The catalogue that these were ordered from have the bolt hole centres listed at 190mm.
Through some searching I found reference to 'Driveline Services Australia' and looked into their cataloge here which looks like it lists the exact same thing.
Has anyone used these before or encountered this problem? Can anyone varify the bolt centres of the OEM centre bearings?
It's not really the fault of anyone and it'd be hard to pick unless you're trying to fit the shaft back onto the car or scrupulously measured every little detail, just curious to know if anyone else has had this issue or knows about it.
Through some searching I found reference to 'Driveline Services Australia' and looked into their cataloge here which looks like it lists the exact same thing.
Has anyone used these before or encountered this problem? Can anyone varify the bolt centres of the OEM centre bearings?
It's not really the fault of anyone and it'd be hard to pick unless you're trying to fit the shaft back onto the car or scrupulously measured every little detail, just curious to know if anyone else has had this issue or knows about it.
