CC GSR front swaybar 21mm ?

[BZY247]

Hey guys,

Can someone please confirm 100% if stock gsr swaybar is 21mm thick ?


Cheers

 

[EVOCPE]

Stock is either 19mm or 22mm

 

[evo-gsr]

↑ Lol!

You've confused the matter now havent you

 

[khubner1]

mine was a 22 when i measured it before fitting up the kframe

 

[EVOCPE]

Could be 20mm

Shhhhh Jamo

 

[evo-gsr]

h34r:

 

[BZY247]

Lol ok 22 it is. Mick ima gona slap u when i see you

 

[EVOCPE]

I just went out and measured my spare GSR sway bar, its 22.5mm

 

[CYBORG-X]

every gsr, m21, and xli swaybar ive measured was 23mm, and every bushing catalogue says it should be 21mm...wft??

 

[EVOCPE]

Yeh I just measured my spare its about 22.5mm, but when u look on ebay they have listings for 19mm and 22mm lol

 

[EVO-00X]

OEM GSR front stabilizer bar is 23mm.
Doubled checked part number MB844453 in Mitsubishi ASA and its 23mm

 

[EVOCPE]

22mm D bushes will be fine, u need them smaller so they are a tighter fit, my spare is worn where the bushes go

 

[NFG]

Digging this up as I'm shopping for sway bar bushings at the moment.

22mm or 23mm for the front? And 18mm for the rear?

 

[BMGTZ]

Dont make a GSR front thicker than standard as they already under steer the way the are.....the reason the for the change in evo two and three..

I use a 21mm rear and get some nice rear slides....Good as long as you have front grip lol

 

[Cranked]

Stock rear is 18mm. I went to a 21mm IIRC and left the front stock. Also seam welded all the sub frames and poly bushed everything.

 

[NFG]

Dont make a GSR front thicker than standard as they already under steer the way the are.....the reason the for the change in evo two and three..

I use a 21mm rear and get some nice rear slides....Good as long as you have front grip lol

I'm not making it bigger, I want to replace the bushes and need to know the thickness.