DIY SUMP GASKET GSR / EVO

[EVO-00X]

When you removed the seal you would have had the circular needle bearing behind it which lives inside the output pinion [the bearing on the left in the pic]. Make sure you have one behind the seal!
The other smaller bearing is 6.32-6.33mm or yeah, 1/4" as advised [see pic].
The 2nd pic is just FYI lol.

 

[4piknup]

fancy that, a metric car from japan, built almost 25 yrs after aussie went metric and it has a 1/4" ball bearing in it...

 

[RVR97]

I found a similar size bearing on the ground after removing the transfer case.

Not sure does it belong to the output shaft, should there be any concern :fuuuuu:?

 

[evo-gsr]

Unless you removed the end cover from your gearbox its from somewhere else.

 

[RVR97]

Nope I have never open the end cover from the gearbox.

I did remove the passenger drive shaft "I moved the shaft to a side enable me to remove the oil pan" is there a bearing there?

 

[evo-gsr]

No.