DYNO TUNER GOLD COAST

[Hyper_Mike]

I'm going to tune mine myself with ECMlink, I have a stocker in atm so i'll throw 1000cc inj and 25g at it and experiment on it before the forged engine goes in........Mwahahaha.

Butt dyno and test and tune for me! $900 can go towards a HX35/HX40 or nitrous when I get bored.

I wish man, I am so nervous about even driving the car without having it tuned first that I think once I get the head done I will just put it straight on a trailer and tow it up to brissy.

 

[Hyper_Mike]

Anyone had any work done by ChipTorque in Nerang before?
Quoted me $1000 for my tune.

 

[htgsr]

Just book it in at PITS. Ring him book it in, never look back.

 

[khubner1]

chip torque do alot of stuff they made the flash tuner that MCM used on the forester

 

[Hyper_Mike]

So after all the choices I have gone with PITS. Was quoted around $1200 including the install and new vacuum line run to the ECU.

 

[htgsr]

Sweet we will all have to t up a test an tune night an go have some fun

 

[khubner1]

mike i strongly suggest you plug it in and atleast turn the key to on before you go (this way you know the ecu receives power) i had to earth out one of the wires on the efi relay to close the circuit

 

[Hyper_Mike]

mike i strongly suggest you plug it in and atleast turn the key to on before you go (this way you know the ecu receives power) i had to earth out one of the wires on the efi relay to close the circuit

Was that when you were using my loom? That sucks I hope it's all good

 

[khubner1]

nah on my home made one so unless there's something buried in the haltech loom that i didn't or couldn't replicate. you may experience the same issue. this was easy enough to fix i n9ow just have another relay that trips the efi relay from the ign switch

 

[htgsr]

How did this thing go?

 

[khubner1]

still at the tuner awaiting work

 

[Hyper_Mike]

How did this thing go?

Yep I'm stillll waiting.

 

[htgsr]

Still waiting?