front cut left overs

[bazeng]

Have you got an oil filter housing at all?
I need a jspec one

 

[GVR40]

sorry bud, MDK87 beat you to it.

 

[bazeng]

Interested in the cams too mate!

I'll pm you about the 4bolt too.

 

[PACEMAKER]

Do you still have the A/C pipe from the reciever dryer to the condensor. Its a small alloy pipe approx 200mm long. Im also wanting the eng sump. If so ill give you $60 for both if they are in good working condition and will pick up tonight if possible.

thanx,
Michael.

 

[Hypo]

Would I see a benefit when fitting the cams if I have a standard ECU and no cams gears?

 

[MDK87]

Would I see a benefit when fitting the cams if I have a standard ECU and no cams gears?

I think so. My ECU only has RS maps and it seems to rev pretty high!

 

[GVR40]

Do you still have the A/C pipe from the reciever dryer to the condensor. Its a small alloy pipe approx 200mm long. Im also wanting the eng sump. If so ill give you $60 for both if they are in good working condition and will pick up tonight if possible.

thanx,
Michael.

probably have that hose. and can have the sump off for you tomorrow.

Cheers

 

[GVR40]

updated

radiator is sold
intake manifold is actually a cyclone

 

[GVR40]

bump, make some offers guys, i wanna get this stuff outta here. if you want pictures just ask and i can get them for you

 

[rob323]

Did you get a dash with that front cut? I'm chasing a foglight switch.

 

[GVR40]

yes, i did get a dash, will search for a foglight switch for you

 

[rob323]

Thanks Craig.

 

[GVR40]

bump.

pulled the rear diff out today and i think it might be mechanical. i tried turning one side whilst holding the other and it was nearly impossible

 

[GVR40]

rob i have that switch for you when you want it, just got to remember where i put it

everyone else, i want this stuff gone make some offers

 

[rob323]

rob i have that switch for you when you want it, just got to remember where i put it

Ah sorry Craig, I realised after my brain fart that being able to operate that switch while wearing race gloves is not going to happen so have gone a different direction. Sorry for not letting you know earlier.

 

[GVR40]

twin pot brake callipers - $200
Cyclone intake manifold - $100 -pending
3 bolt mechanical LSD rear 3.545 - $600
apexi AFC NEO hardly used - $350
heavy duty exedy clutch disc w/oem pressure plate 98% left on disc - $200
alpine mrp-m350 amp 700W monoblock - $100
lanzar 6.5" mid-bass drivers - $50
panasonic cq-c8401 60w*4 head unit - $200
4 way power fused distribution block - $20
stock vr4 rods and crank - $100 -pending

i checked out the block and it has a crack down number 1 cylinder wall.

I want this stuff gone, make me some offers