FS: Entire forged 4G63 setup -all brand new

[OSiRiS]

FS: Entire forged 4G63 setup -all brand new
pistons, rings, pins, rods, bolts, bearings

ALL BRAND NEW!

Removed from boxes to be assembled up and balanced. Never used in engine.

To be sold as an entire set, 4G63. All fully prepped and ready to drop into engine.

MAHLE "sport compact, POWERPAK" forged pistons
MIT367385I13
- bore: 86mm/3.385"
- stroke: 88mm
- rod length: 150mm
- comp. height: 1.367"
- piston weight: 291gm
- pin: 21mm
- inv. dome
- vol -13cc

MAHLE piston ring kit
- top ring: 1.2mm
- 2nd ring: 1.2mm
- oil ring: 2.8mm

MAHLE piston pin kit

SCAT H-Beam forged connecting rods
2-5906-1771-1115-827
- high quality 4340 forged aircraft steel

ARP 2000 rod bolts

ACL Race main bearings

Free shipping anywhere in New Zealand.

PM me all serious offers.

 

[iluszn]

Unless i missed it.

You might want to put a figure up of what it set you back or an estimate of what you want.

 

[EVO85]

Unless i missed it.

You might want to put a figure up of what it set you back or an estimate of what you want.

I thought that was compulsory according to the forum rules!? :?

 

[brisvr4]

It is.
Can you please post up a price please?
If not this will have to be locked until one is advised.


Thanks

 

[JayRome]

Unless i missed it.

You might want to put a figure up of what it set you back or an estimate of what you want.

I thought that was compulsory according to the forum rules!? :?

correct

please put price up as per forum rules

 

[JSTYLE]

well these to buy new would be around $1100AUD

but that said.. you can buy wiseco/je pistons and eagle rods for under 1k landed.

Jon

 

[to4garret]

i am in the market for some forgies,

just pm me a price of what you are after and we can go from there

oh and Daniel and Aisha say hi and thanks for the cruises OSiRiS

 

[OSiRiS]

i am in the market for some forgies,

just pm me a price of what you are after and we can go from there

oh and Daniel and Aisha say hi and thanks for the cruises OSiRiS

lol thanks

I'm not sure what the cost is over in Australia to get some quality forged internals, but I'm looking for NZD$1,500 on the NZ market.

 

[GENUINE E III]

Exactly same set up in my Evo III.

Goes hard too.