GSR parts

4GTuner

Help Support 4GTuner:

CYBORG-X

Well-Known Member
Joined
Apr 8, 2010
Messages
249
Location
St Johns Park
hi all
I'm parting out my gsr, it's still complete so you can see any parts before I take it off.
the parts listed here are all I will be selling, as i'm keeping a lot for a project car.
parts have approx. 15,000kms on them unless stated otherwise.

GSR Prosport coilovers (rebuilt) $350
TD05-14b reconditioned with new genuine E3 rear housing (large flapper) and new 1 bar actuator
new E3 dump housing. Match ported (machined flame ring) and reshaped exhaust manifold.
All new water and oil line to turbo
This is for a 4g93t, and will allow a straight swap onto a gsr engine.. $550 pending

2.5in straight through exhaust to angled cannon, sounds really good. mounts to E3 dump housing $250

Fixed bucket seats (autotechnica) on recaro rails, very comfortable and adr approved. $500

3pt rear strut brace for gsr $130
Mid floor brace 100
strut brace 4pt 100
all bars are ultra racing



car is in st johns park, nsw

I will update as I think of parts to sell
 
how old is the cooler and piping...condition of fins etc? Please pm me some pictures or post them here. I would need it packed and posted to WA. Are you willing to do that?
 
as I said, 15,000kms old was a new cooler, and the piping is factory evo that was acid washed and painted, and the lower pipe is new as the old one rusted out.
fins have minimal damage as its covered a lot by the front bar..
I could pack and post at an additional charge.
 
Sorry all, i hardly ever go on here, and normally i get an email when i've been p'md..but never got any.. will reply back to everybody asap.
If you have further questions my email is [email protected] that will go to me direct...
Thanks all
 

Latest posts

Back
Top